User manual BARTSCHER 100090

[. . . ] In the event of prolonged disuse, empty the corncob from the machine and unplug it from the electrical power supply. The manufacturer shall not be held liable for personal injury or property damage which may be due to: · Maintenance not performed by specialized personnel, when required by this manual or by current standards. The machine was designed to dry and polish cutlery made of stainless steel, chromed steel or silver, using corncob. Do not use it for drying or polishing other materials. [. . . ] Figure 1 ­ CUTLERY DRYER model JET Figure 2 ­ CUTLERY DRYER model MIG Cutlery, with the maximum dimensions shown in Figure 3, is inserted in the entry opening located on the top of the machine. From there, it reaches the bottom of the spiral tunnel. In the tunnel, there is the corncob, which is heated by an adhesive heating element applied to the outside of the bottom of the tunnel, allowing it to reach the required temperature of approximately 80°C needed to disinfect the cutlery. The motor-vibrator, located in the centre of the spiral, allows the cutlery to proceed along the tunnel until the exit opening, located on the front of the machine. The relative movement between the cutlery and corncob allows the corncob to absorb the humidity from the cutlery and to polish it. Near the exit hole, in addition to a perforated track that allows the corncob to return to circulation. There is an electric fan that generates and air barrier capable of keeping the cob in the machine. Figure 4 ­ CUTLERY DRYER control panel, model JET Figure 5 ­ CUTLERY DRYER control panel, model MIG The control panel of the machine is powered at low voltage (24 volts) to avoid risks originating from high-voltage power supply. Main switch: when it is in position 0 it makes it possible to cut the power supply to the machine. When it is in position 1 it provides power to the machine. Voltage present lamp: indicates that voltage is supplied to the machine when the main switch is in position 1. For this reason, cleaning must be performed after at least 15 minutes from machine shutdown! remove the upper lid and remove dust and corncob residue from the machine. To do so, use only a vacuum cleaner, if possible equipped with a narrow nozzle, to reach the least accessible parts. Never use air jets, to avoid dispersion into the environment of residues. When the operation is complete, close the lid and firmly secure the fastening screw. : Before cleaning the inside of the machine, disconnect the power supply by turning the main switch to 0. The machine must be cleaned when it is cold. Follow the directions on the warning/prohibition sign (Figure 10). : Before performing any maintenance, disconnect the power supply to the machine by turning the main switch to 0. The machine must be serviced when it is cold. Considering the simplicity of maintenance, it may be done by the user, provided the aforementioned safety precautions are observed. [. . . ] If your unit requires any repair, contact your dealer's service centre. Once finished using the machine leave it on for 20 minutes to regenerate the corncob. Make sure that the corncob does not get damp. Replace entire corncob supply once every 120 days/600 hours of work. [. . . ]