User manual BARTSCHER 114003

[. . . ] The instruction manual forms part of the product and should be kept near the device and easily accessible for anyone carrying out the installation, servicing, maintenance or cleaning. In this manual, symbols are used to highlight important safety instructions and any advice relating to the device. The instructions should be followed very carefully to avoid any risk of accident, personal injury or material damage. This symbol highlights hazards, which could lead to injury. [. . . ] Any use going beyond the intended purpose and/or any different use of the device is forbidden and is not considered as conventional. Any claims against the manufacturer or his authorized representative as a consequence of experiencing damages resulting from unconventional use are impossible. Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. Only connect the device directly to the wall socket; do not use any extension cords or power strips. Place the device so that the plug is easily accessible and can be quickly removed from its socket in case of necessity. Prior to first use, run 2 to 3 portions of water without coffee through the coffee machine in order to rinse the device (, , Brewing coffee", steps 1-8). After first use (depending on the construction of the system), a small amount of water will always remain in the reservoir. Keep this in mind when pouring water again later. Always fill the water container with an amount of water equal to the capacity of the acrylic jug included with the coffee machine. the amount of coffee brewed will be the same as the amount of water poured. If too much water is poured into the water container, excess water will drain out through the flow hose. Prior to use, rinse the acrylic jug and filter basket with warm water and a mild cleaning agent, then rinse with clean water and dry thoroughly. Wipe the device's exterior with a moist cloth, then dry with a soft cloth. connect the device to an appropriate single outlet. [. . . ] regular dish liquid and water are sufficient to remove marks of fingerprints , grease or dirt. In exceptional cases you may use vinegar- and water dilutions, as well as commercial non-abrasive agents or commercial agents that are used for the purification of stainless steel surfaces. After the cleaning procedure you should use a soft and dry cloth to wipe dry and polish the surface. In order for the equipment you have purchased to function properly, and for the coffee it makes to be of the highest quality, you must regularly cleanse the device to remove calcium deposit buildup! [. . . ]