User manual BARTSCHER A100062

[. . . ]  If positioned on a fitted carpet or a rug, adjust the feet in such a way as to allow room for air to circulate and provide ventilation beneath the washing machine.  Please read this instruction manual carefully it Connecting the cold water and electricity supplies Connecting the water inlet hose  You will find the guarantee and other details relating to Unpacking and levelling Unpacking  Before connecting the inlet hose to the cold water supply, allow the water to flow from the tap until it runs clear. Connect the end of the water inlet hose to the washing machine, screwing it onto the appliance's cold water inlet, situated on the top right-hand side on the rear of the appliance (see figure). Once the washing machine has been removed from the packaging, check that it has not been damaged during transportation. [. . . ] The icons corresponding to the different wash phases will light up during the cycle, indicating the progress. To change a programme while a cycle is in progress, pause the washing machine by pressing the START/PAUSE button; then select the desired cycle and press the START/ PAUSE button again. To open the door while a cycle is in progress press the START/PAUSE button; if the DOOR LOCK indicator light switches off it is possible to open the door. Press the START/PAUSE button again to restart the programme from the point at which it was interrupted. The text END lights up to indicate that the programme has ended. The porthole door may be opened immediately. If the START/PAUSE button flashes, press the button to end the cycle. Open the door, unload the laundry and switch off the machine.  Exception: if the WITHE COTTON programme is selected, the temperature can be increased up to a value of 90°C. To set a delayed start for the selected programme, press the button repeatedly until the desired delay time is displayed (this may be between 1 hour and 24 hours). To disable the function press the button until the is displayed. Empty all pockets and check for loose buttons. • Do not exceed the values indicated in the “Table of Programmes”, which refer to the weight of the laundry items when they are dry. 1 1 1 1 1 1 1 sheet pillowcase tablecloth bathrobe towel pair of jeans shirt 400 150 400 900 150 400 150 - 500 g 200 g 500 g 1200 g 250 g 500 g 200 g Quilts: to wash quilts with a synthetic outer layer, use the bag provided and set the programme to "Duvets". Bathroom laundry and bedlinen: this washing machine can be used to wash any domestic laundry in a single cycle called “Bed & Bath” that optimises the use of fabric softener while saving both time and electricity. we recommend that you use a powder detergent. Stubborn stains: stubborn stains should be treated with solid soap before the garment is washed (use the Cotton programme with pre-wash phase). Load-balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly faster than the normal washing speed. If, after several attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency. If the load is excessively unbalanced, the washing machine continues at distribution speed only instead of the full spin speed. In order to achieve better load distribution and balance, we recommend that large and small garments are mixed when placing the laundry in the machine. Washing advice Shirts: use a suitable programme to wash shirts made from different fabrics and in different colours. [. . . ] the machine continuously fills and drains water. • The end of the outlet hose has not been fitted at a height between 65 and 100 cm from the floor (see “Installation”). • The free end of the hose is underwater (see “Installation”). • If If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the washing machine to load and drain water continuously. [. . . ]