User manual BARTSCHER A120954

[. . . ] If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine. Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer. Remove the four protective screws and the rubber washer with the respective spacer, situated on the rear of the appliance (see figure). [. . . ] Press the button corresponding to the desired function, according to the table below; 2. The function is enabled when the corresponding button is illuminated. Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set. Detergents Function Effect Delays the start of the wash by up to 9 hours. Allows for an impeccable wash, visibly whiter than a standard Class A wash. This option reduces the amount of creasing on fabrics, making them easier to iron. Cuts the duration of the wash cycle by 30%. Comments Press the button repeatedly until the LED corresponding to the desired delay is turned on. The fifth time the button is pressed, the function will be disabled. : Once you have pressed the Start/Reset button, the delay can only be decreased if you wish to modify it. Enabled with programmes: Precautions All Delay Timer Super Wash This function is incompatible with the RAPID function. Never try to do this alone, because the appliance is very heavy. • Before loading your laundry into the washing machine, make sure the drum is empty. Description Saving energy and respecting the environment Environmentally-friendly technology If you only see a little water through your appliance door, this is because thanks to the latest Ariston technology, your washing machine only needs less than half the amount of water to get the best results: an objective reached to respect the environment. Saving on detergent, water, energy and time • To avoid wasting resources, the washing machine should be used with a full load. A full load instead of two half loads allows you to save up to 50% on energy. The pre-wash cycle is only necessary on extremely soiled garments. Avoiding it will save on detergent, time, water and between 5 and 15% energy. • Treating stains with a stain remover or leaving them to soak before washing will cut down the need to wash them at high temperatures. A programme at 60°C instead of 90°C or one at 40°C instead of 60°C will save up to 50% on energy. • Use the correct quantity of detergent depending on the water hardness, how soiled the garments are and the amount of laundry you have, to avoid wastage and to protect the environment: despite being biodegradable, detergents do contain ingredients that alter the natural balance of the environment. In addition, avoid using fabric softener as much as possible. [. . . ] troubleshooting The washing machine leaks. The ON-OFF/DOOR LOCK Led flashes rapidly at the same time as at least one other LED: There is too much foam. • The detergent is not suitable for machine washing (it should bear the definition "for washing machines" or "hand and machine wash", or the like). Service 11 Service GB Before calling for Assistance: • Check whether you can solve the problem on your own (see page 11); • Restart the programme to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Service Centre on the telephone number provided on the guarantee certificate. [. . . ]