User manual BARTSCHER A201100

[. . . ] The priority of operation is placed on the first unit that turned on. € During operation, HEAT and COOL modes cannot activate at the same time for different indoor units. € The power indicator blinks to indicate the indoor unit is standing by for a different operation mode. Outdoor unit Operation conditions Use this air conditioner under the following temperature range. [. . . ] do not expose plants or pet directly to airflow to avoid injury , etc. Do not touch the sharp aluminium fin, sharp parts may cause injury. Do not switch ON the indoor unit when waxing the floor. After waxing, aerate the room properly before operating the unit. Do not install the unit in oily and smoky areas to prevent damage to the unit. Do not dismantle the unit for cleaning purpose to avoid injury. Do not step onto an unstable bench when cleaning the unit to avoid injury. Do not place a vase or water container on the unit. Water may enter the unit and degrade the insulation. Do not open window or door for long time during COOL/DRY mode operation. Prevent water leakage by ensuring drainage pipe is: - Connected properly, - Kept clear of gutters and containers, or - Not immersed in water After a long period of use or use with any combustible equipment, aerate the room regularly. € Do not use water hotter than 40 °C. For seasonal inspection after extended non-use • No obstruction at air inlet and air outlet vents. € These units are mounted inside the ceiling. it uses external air intake vent and air outlet vent to operate. Please consult your nearest dealer for seasonal inspection. € After 15 minutes of operation, it is normal to have the following temperature difference between air inlet and air outlet vents: COOL: ≥ 8 °C HEAT: ≥ 14 °C Daily timer setting To turn ON or OFF the unit at a preset time. 1 2 TIMER/CLOCK MODE UP SELECT OFF/ON DOWN SET 3 4 English How to use / Information / To set the timer CLOCK CANCEL MODE to enter timer mode 1 Press TIMER • Press once to change the display from clock to timer or vice-versa. € Press for 4 seconds to change the display from daily timer to weekly timer or viceversa. 2 Select ON or OFF timer Example: OFF at 22:00 OFF/ON 3 Set the time UP DOWN For extended non-use • Activate HEAT mode for 2~3 hours to remove moisture left in the internal parts thoroughly to prevent mould growth. NON SERVICEABLE CRITERIAS TURN OFF POWER SUPPLY then please consult authorised dealer under the following conditions: • Abnormal noise during operation. € Water/foreign particles have entered the remote control. [. . . ] Press TIMER for 4 seconds to change display to weekly timer. SELECT UP or DOWN until your desired day is or DOWN shown, press to select your 3. press TIMER and SELECT to enter programme setting. DOWN UP or until your desired day to confirm your selection. [. . . ]