User manual BAUKNECHT G9CE3675XS INSTALLATION

[. . . ] To eliminate the risk of burns or fire by reaching over the heated surface units, cabinet storage space located above the surface units should be avoided. if cabinet storage is to be provided , the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12. 7 cm) beyond the bottom of the cabinets. The cooktop must be a specified cooktop that is approved to be installed either alone or over an undercounter built-in oven. [. . . ] Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Using 2 or more people, place cooktop right side up into the cutout. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Excessive Weight Hazard Use two or more people to move and install cooktop. Failure to do so can result in back or other injury. decide on the final location for the cooktop. Avoid drilling into or severing existing wiring during installation. Using 2 or more people, place the cooktop upside down on a covered surface using the foam end posts from the packaging. Make sure that the knobs are not resting on the foam. Remove one strip at a time and apply foam strip adhesive-side down around bottom of the cooktop glass. The clamping brackets can be installed before or after the cooktop is placed into the cutout. Complete the following steps for the option you choose. Using 2 or more people, place the cooktop upside down on a covered surface using the foam end posts from the packaging. Make sure that the knobs are not resting on the foam. Remove the attachment screws for the bracket locations from the bottom of the cooktop base. Select bracket mounting holes that will allow the bracket to extend far enough out from the cooktop for the installation of 2½" (6. Using 2 or more people, place cooktop right side up into the cutout. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Remove the attachment screws for the selected bracket locations from the bottom of the cooktop base. Select bracket mounting holes that will allow the bracket to extend far enough out from the cooktop for the installation of 2½" (6. [. . . ] Connect the two black wires together using the UL listed wire connectors. Connect the two red wires together using the UL listed wire connectors. Connect the green or bare cooktop cable wires to the white (neutral) wire in the junction box using the UL listed wire connectors. Use a screwdriver to tighten the screws against the countertop. [. . . ]