User manual BAUKNECHT GGG390LX DIMENSIONS

[. . . ] Usually, LP gas suppliers determine the size and materials used in the system. NOTE: Pipe-joint compounds that resist the action of LP gas must be used. Flexible metal appliance connector: q q C** If local codes permit, a new CSA design-certified, 4 to 5 ft (122 to 152. 4 cm) long, ¹/" (1. 3 cm) or ³/" (1. 9 cm) I. D. , flexible metal appliance connector may be used for connecting range to the gas supply line. A D A ¹/" (1. 3 cm) male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator. q Do not kink or damage the flexible metal tubing when moving the range. [. . . ] q This range is factory set for use with Natural gas. See "Gas Conversions" section. The model/serial rating plate located behind the control panel has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP gas conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. See "Gas Conversions" section. ® *Model/serial/rating plates may be rotated up from behind the control panel for viewing from the front of the range. **Range can be raised approximately 1" (2. 5 cm) by adjusting the leveling legs. Dimension given is from wall to front of oven door and will vary based on electrical outlet receptacle installation. ELECTRICAL REQUIREMENTS IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22. 1. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate. q A 120 volt, 60 Hz. , AC only, 15-amp fused, electrical circuit is required. A timedelay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided. q Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded. Page 1 of 2 TEFLON is a registered trademark of E. I. Du Pont De Nemours and Company. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. [. . . ] NOTE: 24" (61. 0 cm) minimum when bottom of wood or metal cabinet is covered by not less than ¹/" (0. 64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0. 015" (0. 4 mm) stainless steel, 0. 024" (0. 6 mm) aluminum or 0. 020" (0. 5 mm) copper. 30" (76. 2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet. 14" *** (35. 6 cm) 1½" (3. 8 cm) 1¼"* (3. 1 cm) 2¼" (5. 7 cm) 8½" (21. 6 cm)** gas line location Page 2 of 2 Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. [. . . ]