User manual BAUKNECHT GXW7336DXS

[. . . ] For questions about features, operation/performance parts, accessories or service, call: 1-800-253-1301 In Canada, for assistance, installation and service, call: 1-800-807-6777 or visit our website at. Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. [. . . ] A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 A 120 Volt, 60 Hz. If the house has aluminum wiring, follow the procedure below: 1. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. The following example falls within the maximum recommended vent length of 35 ft (10. Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood. Before making cutouts, make sure there is proper clearance within the ceiling or wall for exhaust vent. Check your ceiling height and the hood height maximum before you select your hood. IMPORTANT: All screws must be installed into wood. If there is no wood to screw into, additional wall framing supports may be required. 8 mm) pilot holes at all locations where screws are being installed into wood. 4 mm) gap between the wall and the back of the screw head to slide range hood into place. Determine which venting method to use: roof or wall. Excessive Weight Hazard Use two or more people to move and install range hood. Failure to do so can result in back or other injury. Using 2 or more people, lift range hood onto covered surface. Position vent cover bracket on wall about ¹/" (3. 5 mm) holes for wall anchors and insert anchors flush with the wall. 4 cm) above the range to the bottom of the hood. Tape template in place, aligning the template centerline and bottom of template with hood bottom line and with the centerline marked on the wall. Determine and make all necessary cuts in the wall for the vent system. Run the home power supply cable according to the National Electrical Code or CSA Standards and local codes and ordinances. [. . . ] Factory specified parts will fit right and work right because they are made with the same precision used to build every new appliance. To locate factory specified replacement parts in your area, call us or your nearest designated service center. Service calls to repair or replace appliance light bulbs, air filters or water filters. Consumable parts are excluded from warranty coverage. [. . . ]