User manual BAUKNECHT SKT60S INSTALLATION INSTRUCTION

[. . . ] Plan your installation using these instructions in conjunction with the Use & Care Guides provided with the refrigerator and freezer. The metal parts can be damaged if they are dropped. Make sure there is enough area, approximately 7 ft (2. Lay a drop cloth on the floor to cushion the parts and cover the flooring. [. . . ] Using two pan head Phillips screws, fasten the top trim extrusion by inserting a screw through the predrilled holes at each end. Using a carpenters level, make sure the sides are plumb, and shim as necessary. NOTE: Shims are not provided with the trim kit. Using four pan head Phillips screws (two on each side), fasten both the left-hand and right-hand side trim extrusions to the opening or cabinetry. Use several pieces of tape to temporarily hold the assembly in place as shown. Remove the tape and lower the trim assembly back to the floor. Using a cordless drill and ¹/" diameter drill bit, drill holes where marked. NOTE: Some cabinetry or wall materials may require predrilled holes using a /" diameter drill bit. Align the top extrusion against the opening, so that it is tight and flush with the front surface of the wall opening or cabinetry. Excessive Weight Hazard Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury. From below and behind the top trim extrusion, insert a pan head Phillips screw through the predrilled center hole of the top trim and into the wall opening or cabinetry. When Moving Your Freezer or Refrigerator: Your freezer and refrigerator are heavy. When moving the appliance for cleaning or service, be sure to cover the floor with cardboard or hardboard to avoid floor damage. Always pull the appliance straight out when moving it. Do not wiggle or "walk" the appliance when trying to move it, as floor damage could occur. Place the freezer and refrigerator in front of the opening (freezer on the left, refrigerator on the right). Cover the floor with cardboard or hardboard to avoid floor damage. Slide the first appliance into the opening far enough to connect the power cord to the electrical outlet. Adjust the leveler legs so that each appliance is level and plumb and at the same height as the other appliance. NOTE: The freezer and refrigerator each have two front leveler legs that are adjustable. The back of each cabinet rests on two fixed supports. [. . . ] These will be used to fasten the bracket. Insert one screw through the lower bracket and thread it into the cabinet. Align the bracket holes with the holes in the appliances and install the remaining three screws. Make sure the appliances are still level. [. . . ]