User manual BAUKNECHT XHPC155XL INSTALLATION INSTRUCTION

[. . . ] remove the drawer from the slides and set aside. ImPoRtAnt: If your washer and dryer are already installed, they must be uninstalled. To avoid possible damage to the washer, the transport bolts on the back of the washer must be in place before installing the pedestal. To avoid suspension and structural damage, your washer must be properly set up for relocation by a certified technician. [. . . ] Pull the dryer away from the wall so that you will have enough space for the installation. Locate the leveling feet in the package removed from the pedestal drawer. Thread a jam nut onto each foot so that the nut is 1" (25 mm) above the foot base. Thread the feet into the threaded holes located at each corner of the pedestal, until the jam nuts touch the bottom of the pedestal. Note: Do not tighten the jam nuts at this time. Pedestal box To avoid floor damage and ease installation and handling, unfold the empty pedestal box flat and place it next to the washer. Move the pedestal against the washer bottom. The front of the pedestal cabinet should align with the washer cabinet as shown below. Leave a space of about 3/8" (10 mm) between the screw head and the bottom of the washer. Note: If your washer has leveling feet installed, remove them. Do not install the feet that came with the new washer. Front View from above Position the pedestal toward the front of the washer and install the two remaining hex-head sheet metal screws. Locate the leveling feet in the package removed from the pedestal drawer. Thread a jam nut onto each foot so that the nut is 1" (25 mm) above the foot base. Thread the feet into the threaded holes located at each corner of the pedestal, until the jam nuts touch the bottom of the pedestal. Note: Do not tighten the jam nuts at this time. Pedestal box To avoid floor damage and ease installation and handling, unfold the empty pedestal box flat and place it next to the dryer. Move the pedestal against the dryer bottom. The front of the pedestal cabinet should align with the dryer cabinet as shown below. Front view from above Partially install two of the #12 x 5/8" hex-head sheet metal screws in the indicated holes. [. . . ] Rock washer/dryer back and forth to make sure all four feet make solid contact with floor. When the washer/dryer is level, use a 9/16" open-end wrench to securely tighten all four jam nuts against the pedestal. Not Level level Not Level If not level, adjust pedestal feet up or down, repeating as necessary. Pull both drawer slides out and reassemble the drawer to the drawer slides with the two hex-head screws. [. . . ]