User manual BAZOO SLIMBOARD QUICK GUIDE

[. . . ] To reduce the risk of fire, explosion, electric shock, or personal injury when using your hob, follow these basic safety precaution. Unplug the power plug from the wall socket. Make sure the machine is grounded to prevent electric shock. Note Important 2_ using this manual SLIMBOARD_XSA_DG68-00348A-EN. indd 2 2011-06-07 6:47:02 safety instructions The safety aspects of this appliance comply with all accepted technical and safety standards. [. . . ] Additional silicon sealant must not be applied; this would make removal more difficult when servicing. · The hob must be pressed out from below when removed. · A board is to be installed underneath the hob. · The ventilation gap between the worktop and front of the unit underneath it must not be covered. The surface temperature on the underside of the electric hob may exceeds 95°C. CAUTION To avoid hazard, under bench access must be restricted. 12_ installing the hob SLIMBOARD_XSA_DG68-00348A-EN. indd 12 2011-06-07 6:47:03 CONNECTING TO THE MAINS POWER SUPPLY Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. Shut off power to circuit before connecting wires to circuit. WARNING INSTALLING THE HOB The heating element voltage is AC 230 V~. The appliance also works perfectly on networks with AC 220 V~ or AC 240 V~. The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. Residual heat indicator : An icon for residual heat appears in the display if the cooking zone is so hot that there is a risk of burning. Power Boost : Use this function to heat up the contents of the pan faster than maximum power level ` '. (The display will show ` '. ) Auto Pan-Detection : Each cooking zone incorporates an automatic pan-detection system, the system is calibrated in order to recognize pans of a diameter just slightly smaller than the cooking zone. Pans must always be placed centrally on each cooking zone. Digital displays : The four display fields are assigned to the four cooking zones. They show the following information: the appliance has been switched on, to , selected heat settings, residual heat, the child lock is activated; and error message, the touch sensor button has been touched for longer than 60 seconds. error message, when the hob is overheated because of abnormal operation. (example : operation with empty cookware) error message, cookware is unsuitable or too small or no cookware has been placed on the cooking zone. · · Keep warm : Use this function to keep warm cooked food. (The display will show ` '. ) · Water boiling : Use this fuction to boil water. (The display will show ` '. ) After completion, cooking zone will automatically reduce to a lower power level. Use Water boiling fuction only to heat water. [. . . ] Keep all items and materials that could melt, for example, plastics, aluminium foil and oven foils, away from the ceramic glass surface. If something of this nature melts onto the hob, it must be removed immediately with a scraper. · · · · 30_ cleaning and care SLIMBOARD_XSA_DG68-00348A-EN. indd 30 2011-06-07 6:47:10 warranty and service FAQS AND TROUBLESHOOTING WARRANTY AND SERVICE A fault may result from a minor error that you can correct yourself with the help of the following instructions. Do not attempt any further repairs if the following instructions do not help in each specific case. WARNING Repairs to the appliance are to be performed only by a qualified service technician. Improperly effected repairs may result in considerable risk to the user. [. . . ]