User manual BBE SOUND 262

[. . . ] v MODEL 262 SONIC MAXIMIZER USER MANUAL IMPORTANT SAFEGUARDS To prevent fire or shock hazard, do not expose the unit to rain or moisture. ATTENTION: RISQUE DE CHOC ELECTRIC-NE PAS OUVRIR. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated `dangerous voltage' within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point, within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. [. . . ] The BBE Process gives the user a more detailed perception of tonality, added `bite' and an increase in clarity. The low frequency range of the program material will be tightened while the high end will be crystal clear without adding or creating any additional noise or harmonic distortion. When the knob is in its minimum position, completely counter-clockwise, no process is taking effect. Turning the knob clockwise, will introduce the BBE Process. Adjust the knob to mix the desired amount of BBE Process to suit your taste. The BBE Process also has its own in/out switch for comparison of the processed to unprocessed signal located on the front panel. Use the BBE Process as an extension of the tone controls. The BBE Process is not an effect, but a sonic improvement. To start, set the BBE PROCESS knob to its 12 o'clock position, then adjust accordingly. CHANNEL B: LO CONTOUR CONTROL: Same as Channel A Lo Contour Control. CHANNEL B: PROCESS CONTROL: Same as Channel A Process Control. BBE FUNCTION: This switch engages the BBE Process. When depressed, the `IN' position, the indicator LED will illuminate Green indicating that the BBE Process has been engaged. When in the `OUT' position, the indicator LED will illuminate RED, indicating that the BBE Process has been disengaged. BBE 262 INSTALLATION INSTRUCTIONS - 3 REAR PANEL CONNECTIONS 6. A. C. INLET: This jack is for connecting the 12 VAC power source. POWER SWITCH: This push button switch applies AC power to the BBE 262 Sonic Maximizer and is used for turning the unit on and off. FOOTSWITCH INPUT: This mono jack is for connecting any mono shorting footswitch. Using the remote switching jack defeats the front panel function switch and allows the selection of process on/off via footswitch. UNBALANCED OUTPUTS: Each channel is equipped with a 1/4" phone jack. Each output sends a low impedance line level signal. The recommended single load impedance is at least 10k Ohms. (The `load' is determined by the input impedance of the next subsequent component in the signal chain). [. . . ] voltage on the positive terminal of capacitor `C15'. The voltage should be between +18VDC and+20VDC. voltage on the negative terminal of capacitor `C18'. The voltage should be between -18VDC and -20VDC. [. . . ]