User manual BBE SOUND 422A

[. . . ] For example, you should not place the product on a bed, sofa, rug, or similar surface that might block the vent openings, or placed in a built-in installation, such as a bookcase or cabinet that might impede the flow of air through the ventilation openings. Wall or Ceiling Mounting - If your appliance can be mounted to a wall or ceiling, mount it only as recommended. Accessories - Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. [. . . ] Setting up the Sonic Maximizer as an echo send device like a digital reverb is not recommended as the processed effect is not fully realized when summed with the original source audio. In order to reduce the risk of damage to any equipment, properly connect all cables and power cables before turning on any components in the system. 4 882i SONIC MAXIMIZER Front Panel Controls 1. LED DISPLAY: The LED display is used to indicate the output signal level of the BBE 882i. Each number on the front panel corresponds to the output signal level, measured in decibels. Example: The "+10" indicates a 10dBu signal level, "0" refers to 0dBu, and so on. Once an input signal level has been established, increasing the BBE PROCESS and LO CONTOUR will increase the output signal and cause more LEDs to illuminate. The Clip LED monitors the input signal level. The Clip LED will illuminate at +20dBu, giving a 3dBu warning of the impending distortion at +23dBu, the actual clip point. LO CONTOUR: Each channel is equipped with a LO CONTOUR CONTROL. This control regulates the amount of phase corrected bass frequencies. PROCESS: Each channel is equipped with a PROCESS CONTROL. The output impedance of the BBE 482i is 1 k ohms. NOTE: Actual output level will vary due to the selected position of the BBE Process, and the actual input signal level. INPUT: The input of the BBE 482i is an unbalanced connection. Although is can be either a 1/4" Phone Plug or an RCA Plug, it is recommended that only one input source is used. Both jacks are the same point electronically, however, due to the input/output impedance characteristics of most audio devices, a loss of signal may occur and/or damage to a component if both inputs are utilized. The input impedance of the BBE 482i is 47k Ohms. CHANNEL A: These connections function the same as CHANNEL B. WARNING!To prevent possible speaker or amplifier damage, always power-up peripheral devices first, wait 10 seconds, and then turn on the power amplifier. Acoustic guitars processed with the BBE Sonic Maximizer have a breathtakingly natural sparkle and presence. Bassists will delight in the BBE Sonic Maximizer's ability to bring much more punch to the bottom end without muddying up the midrange. The BBE Sonic Maximizer is also great for keyboard rigs, with everything from the latest samples to a vintage Rhodes benefiting equally from the patented BBE process. Recording Systems The BBE Sonic Maximizer can be used as an effect on individual tracks or applied overall during mixdown. [. . . ] If this is not possible, call BBE Sound, Inc. directly at (714) 897-6766, extension 116 to obtain a "RETURN AUTHORIZATION". Include a copy of the bill of sale with the unit when it is shipped to BBE Sound, Inc. As the repair turnaround time is minimal, we request that the unit be sent to BBE Sound, Inc. [. . . ]