User manual BBE SOUND 702

[. . . ] For example, you should not place the product on a bed, sofa, rug, or similar surface that might block the vent openings, or placed in a built-in installation, such as a bookcase or cabinet that might impede the flow of air through the ventilation openings. Wall or Ceiling Mounting - If your appliance can be mounted to a wall or ceiling, mount it only as recommended. Accessories - Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. [. . . ] There are two separate channels that share the same front panel Lo Contour control and Process controls for ganged-stereo operation. A single function button switches the BBE process on or off in both channels, which is useful for comparing the processed sound to the unprocessed sound. An LED next to the function button glows green when the BBE process is on and red when the process is off. The Lo Contour control is for adjusting the level of phase corrected low frequencies in the program material. The Process control is for adjusting the level of phase corrected high frequencies in the program material. APPLICATIONS Music and P. A. Systems The BBE Sonic Maximizer is a welcome addition to any live sound P. A. system because the BBE circuit dramatically improves the clarity and intelligibility of vocals and musical instruments. Night club and mobile DJ systems will also benefit greatly from the BBE Process, with more depth, detail and punch over the entire mix. The BBE Sonic Maximizer can be hooked up to any P. A. or DJ sound system exactly like an equalizer would. When using in conjunction with an equalizer, the Sonic Maximizer should be added after the equalizer in the signal chain. This adjustment ranges from 0dB (fully counter-clockwise) to +12dBu (fully clockwise) at 5kHz relative to the input. CLIP LED INPUT B: When illuminated this LED indicates that the output of the 382i has reached +15dBu. PROCESS SWITCH: This push button switch allows for quick comparison of processed with unprocessed sound. When the switch is pushed in, the process is on and the indicator LED is green. When the switch is out, the process is off and the indicator LED is red. POWER: This switch controls primary power to the BBE 382i. Rear Panel Connections 1. AC POWER CORD INLET: Plugs into AC power receptacle. FUSE: Insert a flat blade screwdriver into the fuse holder located in the bottom portion of the AC Power Cord inlet. Carefully pry the fuse holder free from its compartment to access fuse. (Note: Replace with 250VAC, 200mA fastblow type fuse. AC SELECTOR SWITCH: This switch is set at the factory to match the AC power requirements of the country where it will be sold and should only be adjusted by a qualified technician. [. . . ] If this is not possible, call BBE Sound, Inc. directly at (714) 897-6766, extension 116 to obtain a "RETURN AUTHORIZATION". Include a copy of the bill of sale with the unit when it is shipped to BBE Sound, Inc. As the repair turnaround time is minimal, we request that the unit be sent to BBE Sound, Inc. [. . . ]