User manual BEBE CONFORT AXISS

[. . . ] 3 EN ( IMPORTANT ) seat or the seat belt without consulting the manufacturer. €  o not use the child restraint device without the cover. Do D not replace the seat cover with a cover other than that recommended by the manufacturer, because it will have a direct effect on the functioning of the child restraint. € Folding seats must always be locked in place  •  fter purchasing, install the seat in your vehicle. [. . . ] 2 a 2 -  rasp the handle, then, G while holding it in the unlocked position, take hold of the seat with the other hand to turn it towards you. Before using your Axiss for the first time, it is important to check that the wedges from the packaging to protect the strap-guides have been removed, and if they are still in place, remove them. THE SEAT MUST BE INSTALLED FACING FORWARDS 1 -  ass the lap safety belt P behind the two strap guides (a) first the side closest to the door, then (b) around the seat. 2 -  ass the lap safety belt P through the two strap guides (a) around the rim of the base. IMPORTANT: make sure that the lap strap, is well tightened, that it lies flat all around the base, and that it is definitely behind the 4 strap guides. 3 -  wivel the seat of the S unit towards you while operating the lever (a). While holding it in the unlocked position, take hold of the armrest farther away from you and (b) swivel the seat towards you. IMPORTANT: the lever under the base must first be positioned to suit the desired direction of rotation (see page 6). T 4 -  wist the tension T adjuster round until it cannot move any further. 5 - a) Pass the belt through ( the strap guide located at the top of the base. (b) Slide the belt through slot in the tensioner spindle. ( ) 2 - a) Push button (1) and ( push the lever as far as possible (b), while holding in the button (1) and pull on the belt (2) to unwind it from the spindle. (c) Now you can remove the belt from the spindle. 1 IMPORTANT: il n’est pas possible de dérouler la ceinture de l’axe si la manette du tendeur n’est pas basculée au maximum. C IMPORTANT: It is not possible to unwind the belt from the spindle if the tension adjustment lever has not been pushed all the way. 3 -  ndo the safety belt (a) U then detach it from the top strap guide (b) and the strap guides located on the outside of the base. IMPORTANT: Even if the child is not seated in it, the Axiss seat must always be properly restrained by the seat belt. If it were not, it could actually become a projectile and present a danger for the occupants of the vehicle. It is necessary to adjust the harness to your child’s height. * The harness straps must be positioned just at the height of the child’s shoulders. 2 -  lide the headrest up S or down, according to the size of the child. Push on the headrest to lock it into the selected position. [. . . ] Slide (c) the harness clasp and buckle through the slits in the seat cover. 5 -  ass the strap protectors P through the slits of the seat cover as you remove it. IMPORTANT: Never remove the polystyrene or foam parts located under the seat cover: they contribute directly to the effectiveness of the Axiss seat. - During reassembly make sure that the harness straps are not twisted and are completely flat as they pass through the harness clasps (a). [. . . ]