User manual BEBE CONFORT AXISS UP

[. . . ] € Installing the GROUP 1 seat facing the front, pages 8/9/10. € Placing your child in the seat, page 13. € Removing your child from the seat, page 14. Direction lever (to select whether to swivel the seat left or right). [. . . ] 7 FR - EN INSTALLATION FACE A LA ROUTE - FORWARD-FACING INSTALLATION 4 -  ivotez le tendeur au P maximum jusqu’à la butée franche 4 -  wist the tension T adjuster round until it cannot move any further. 5 - a) Pass the belt ( through the strap guide located at the top of the base. (b) Slide the belt through slot in the tensioner spindle. I MPORTANT: Make sure there is no slack in the lap section of the belt by gently pulling on it. 6 -  oving the lever upward M several times (but do not push the button on the lever), the belt will wind around the spindle until it is stretched tight. IMPORTANT: in the final position, the handle must be turned down. IMPORTANT: Some vehicles do not maintain the strap in the strap guide on the side closest to the door. A green T indicator will appear at the top of the base to indicate that the seat is locked in the forward-facing position. IMPORTANT: even when not in use, it is advisable to lock the Axiss seat in the forwardfacing position for driving. IMPORTANT Check that the child seat is properly installed. It is important for your child’s safety that you fit the belt correctly. The vehicle belt must be fixed along the red markings/ positioning points on the Axiss BébéConfort seat. Please also read the label on the side of the Axiss Bébé Confort seat. Never fit the belt in any way other than as shown. IMPORTANT: After you have finished installing your child restraint seat, check the following points and correct as required. IMPORTANT: when the child is seated in the Axiss seat, the seat must be locked in the forward-facing position before setting off. iMPORTANT: The belt is securely fastened and is not twisted. ATTENTION : pour faciliter le verrouillage de l’assise (témoin vert) dans certains véhicules, il peut être nécessaire d’exercer une pression en haut de l’assise WARNING : to enable the seat to lock into position (green indicator), in some vehicles it may be necessary to exert pressure on the top of the seat. If the seat is not stable: •  djust the height of your vehicle’s head rest. The head A rest must never be in contact with the Axiss seat. € f possible and if necessary, adjust the angle of your I vehicle seat to ensure it is in contact with the base. If you are finding it hard to swivel the seat or to secure the seat in the forward-facing position (green indicator). [. . . ] Cette garantie est conforme à la Directive Européenne n° 1999/44/CE du 25 Mai 1999 guarantee certificate Dear Customer, Thank you for the confidence you have shown in us by choosing one of our products. We hope it will meet all your expectations. This certificate indicates that this product has been manufactured according to the quality standards applicable and that it has been subjected to numerous checks during the various manufacturing stages. Should an anomaly occur during the warranty period, we will respect the conditions stipulated in the guarantee. [. . . ]