User manual BEBE CONFORT BABY COQUE STREETY FIX

[. . . ] For your own safety and that of your child, always place your child in the safety seat no matter how short the journey you are making. Even a slight accident can turn your child into a projectile. Always keep the child safety seat fitted even when the child is not being carried. For a child weighing less than 13 kg (up to about 12 months of age). [. . . ] WARNING:To avoid any risk of a fall, your child should always be fastened into the seat. IMPORTANT: Before carrying the seat, check that the carrying handle is locked in place. IMPORTANT: For your child's safety, you are strongly advised not to place the Streety. Ensure the baby is placed correctly in the seat, its back firmly against the back of the seat. Slide both plastic tongue sections together (A). Insert both tongue sections in the buckle, you will hear a loud click locking them in position (A). Pull the adjuster belt at the front of the shell tight, so that the child is firmly secured with the harness belt (the belt system). The harness belt (belt system) must be adjusted to suit your child's body (D). The harness shoulder belts must be threaded through the slots nearest to the shoulders of the child (C). Pull the shoulder belts through the slots in the cover and the shell (D). Thread the shoulder belts through the correct slots in the shell and cover (C). Pull both harness shoulder belts simultaneously towards you (B). to tighten: · Pull the adjuster belt at the front of the shell tight until the harness belt lies firmly against the child. The end of the adjuster belt can be fastened on to the hooks at the front of the shell. Please pay attention to the following when installing the car safety seat in the car. Do not use a child safety seat if the vehicle is equipped with a front airbag. This does not apply to so-called side airbags. Note the difference between the lap belt and the shoulder belt when installing the seat in the car. Always place the seat in a rearward facing position on the passenger seat or back seat, the carrying handle must be placed in an upright position (E). Guide the lap belt of the 3-point seat belt through the blue marked belt hooks on the front and through the lap belt hooks. Fasten the seat belt into the buckle (F). Place the car shoulder belt around the back of the seat and hook it into the bright blue marked belt hook at the rear (G). [. . . ] Use and purpose other than those indicated in the instructions for use, . Installation not in accordance with the instructions, . repair carried out by a non-approved person or retailer , . Replacement of any parts subject to wear (wheels, areas which rub, etc. [. . . ]