User manual BEBE CONFORT CREATIS FIX

[. . . ] €  lways retain the instructions for future use, a storage pocket for this has been A provided on the child’s safety seat. N •  his child safety seat is effective only if the fitting instructions are followed. T •  or your own safety and that of your child, always place your child in the safety F seat no matter how short the journey you are making. €  ven a slight accident can turn your child into a projectile. [. . . ] CAUTION: when passing the lap belt through the slot in the shell, always ensure that it is not twisted. 3 - When the lap belt has been threaded through the slots in the shell, slide it from left to right several times to check that it slides freely. 4 - Slide the diagonal belt behind the shell and then pull it firmly to tension the lap belt and to press the safety seat against the vehicle’s seat squab. 5 - Insert the shoulder belt into the belt guide at the back of the structure. 6 - Tighten the shoulder belt once it has been inserted into the belt guide (5) at the back of the Creatis. 7 - Thread the diagonal strap through the guide on the side of the seat and tighten it. 8 - NOTE you have now completed the installation of your Créatis. €  heck that the vehicle belt is correctly fastened (a), and that the belt has C been correctly positioned at points b - c - d - e. € Check that the vehicle’s belt is not twisted. 11b - Place the child in the seat, arrange the shoulder straps and then attach them to the harness buckle. a click will indicate that it is locked. Adjust the harness to suit the child by pulling on the adjustment strap. WARNING: Always fasten the child into the seat. 9 - WARNING: use the reducing cushion from 0 to 3 months maximum ONLY with the headrest in its lowest position. 10 - Lengthen the shoulder straps of the harness by pressing on the adjustment latch and pulling on the shoulder straps. WARNING: do not pull on the shoulder pads but rather on the shoulder straps of the harness. 11a - To make it easier to get your child into the seat, put the harness in the elastic retainers located on either side of the seat. 12 - Check that the shoulder harness is levelled with the child’s shoulders. Adjusting the height of the shoulder straps of the harness 13 - Lengthen the shoulder straps of the harness by pressing on the adjustment latch and pulling on the shoulder straps (10). Take hold of the top of the headrest (A) to unlock it by folding it forward, then adjust the length of the harness shoulder straps (B) by raising or lowering the headrest. 14 - Push the headrest to the rear to lock it into the desired position. WARNING: Never place your child in the carrycot on a raised surface, except on the stand approved and sold by the manufacturer. [. . . ] CAUTION: Whilst inserting the lap belt into the guides, take care that it does not become twisted. IMPORTANT: Your seat is correctly mounted if you hear a “click” and the indicator on the button (orange strip) is visible. 5 - Insert the shoulder belt into the belt guide on the back of the structure (A), then into the belt guide on the side of the seat (B), and tighten (C). IMPORTANT: you have now finished installing your Creatis. [. . . ]