User manual BEBE CONFORT ISEOS GR 1 FITTING FORWARD FACING INSTRUCTIONS

[. . . ] This approval does not remove the necessity for care and respect for the Highway Code. After putting the child in the car seat, ensure that the car seatbelt is sufficiently taut by pulling the belt. ensure also that the belt does not become twisted THE CHILD: · Never leave a child unsupervised. Never leave your child alone in the vehicle. [. . . ] If so, and you are able to deactivate the airbag, you can use it facing forwards in your vehicle. This device should be used only on approved vehicles equipped with 3 point/static/inertia reel seat-belts that are approved in accordance with EEC/UN regulation N° 16 or other equivalent standard. For the comfort and safety of your child, pull the front passenger seat forwards. The harness should be adjusted to the size of the child by adjusting the shoulder straps. The lowest position of the harness straps (A) should be used with the small protectors of your seat (voir page 12). 1 - Regulate the semi-reclining position by turning the grey button on the left as far as it will go. 4 - Fasten the car belt then place the car seat on the seat. To help the belt pass through the blue hooks, we advise you to put the car seat in upright position. Once you have done this, always check that the strap is properly positioned in the blue loops. 7 - Pass the diagonal belt behind the back of the seat, thread it through the loops (a) and (b) and pull hard on the strap to make sure it is tight (c) and (d). The lowest position of the harness straps (A) should be used with the small protectors of your seat. Check that the child car seat is stable. PLACE THE CHILD IN THE CHILD SEAT 1 - Fasten the harness shoulder straps and the buckle cover to their hooks. 2 - Place the child in the seat, and then unhook the harness shoulder straps from their hooks, and unhook the buckle cover from the adjustment knob. 3 - Fasten together parts (a) and (b), and then push them into the buckle (c) until you hear a Click!4 - Pull firmly on the chest pads on the shoulder straps to put them in the proper place. TAKING THE CHILD OUT 6 - Press the adjuster while pulling on the harness shoulder straps (hold the shoulder straps and not the chest pads). 7 - Fasten the harness shoulder straps and the buckle cover to their hooks. Turn the grey button to the right to move the seat into upright position. Turn the grey button to the left to recline the seat To move the sides apart, turn the black button to the right. Before dismantling, note carefully where all the various parts are on the child seat so that everything can be reassembled properly. 1 - Loosen the shoulder straps and release the harness buckle, and then put the seat in the reclined position. [. . . ] Any product sent directly to the manufacturer will not be covered by the guarantee. This guarantee conforms with European Directive No. GB For restraining devices with the ISOFIX version, please consult the NOTES FOR THE USER on the back page of the instructions. More so than with any other product, a restraining device (carrycot or car seat) must be properly fitted. [. . . ]