User manual BEBE CONFORT ISEOS NEO

[. . . ] For Group 1 (babies from 9 to 18kg) ): the seat must be Fitted in a forward-facing position on the rear seats of the vehicle. The child car seat is to be installed facing forwards. Never install this child car seat facing backwards. The manufacturer's liability is limited to what is covered under the European Regulation (R44). [. . . ] 3 - P ass the seat-belt between the base and the seat of the child seat. 4 - T ake the seat-belt from the other side of the car seat and fasten securely. 5 - P ass the strap through the strap buckle only on the side with the seat belt inertia reel and lock it. 6 - T ighten the seat-belt by pulling very firmly on the diagonal strap (the strap buckle has a non-return mechanism to keep the strap taut). 7 - S lide the seat-belt through the seat-belt lock at the top of the car seat backrest and pull it tight. 8 - L ower the switches to move the tensioner. IMPORTANT : you have completed the installation of the child car seat, with the 3 point car safety belt. Check that the child car seat Is securely fastened and that it is not twisted. Check that the strap buckle is properly fastened and the seat-belt taut. Shoulder straps and the buckle cover to their hooks. 2 - P lace the child in the seat, and then unhook the harness shoulder straps from their hooks, and unhook the buckle cover from the adjustment knob. 7 - T hread the shoulder straps back through the two chest pads, then through the corresponding slits towards the back of the car seat. Hook the shoulder straps back onto the catch plate. For easier access to the top slits in the back of the car seat, put the car seat in the upright position. For easier access to the bottom slits in the back of the car seat, put the car seat in the reclined position. 8 - B efore replacing the wallet, tighten the shoulder straps by pulling firmly on the adjustment strap. Then replace the instructions wallet, concealing the catch plate behind it (fold of wallet at the top). IMPORTANT: always have the wallet in place, even if the instructions are not inside it. If it is not in place, this could cause problems. Before using the seat again check that the harness is working properly. Before dismantling, note carefully where all the various parts are on the child seat so that everything can be reassembled properly. 1 - L oosen the shoulder straps And release the harness buckle, and then put the seat in the reclined position. [. . . ] Any product sent directly to the manufacturer will not be covered by the guarantee. This guarantee conforms with European Directive No. The NOTES FOR THE USER on the back page of the instructions. For restraining devices with the vehicle seat-belt version, please consult the NOTES FOR THE USER below. [. . . ]