User manual BEBECONFORT AXISS

[. . . ] € Installing the GROUP 1 seat facing the front, pages 8/9/10. € Placing your child in the seat, page 13. € Removing your child from the seat, page 14. Direction lever (to select whether to swivel the seat left or right). [. . . ] 5 - a) Pass the belt ( through the strap guide located at the top of the base. (b) Slide the belt through slot in the tensioner spindle. I MPORTANT: Make sure there is no slack in the lap section of the belt by gently pulling on it. 6 -  oving the lever upward M several times (but do not push the button on the lever), the belt will wind around the spindle until it is stretched tight. IMPORTANT: in the final position, the handle must be turned down. IMPORTANT: Some vehicles do not maintain the strap in the strap guide on the side closest to the door. A green T indicator will appear at the top of the base to indicate that the seat is locked in the forward-facing position. IMPORTANT: even when not in use, it is advisable to lock the Axiss seat in the forwardfacing position for driving. IMPORTANT Check that the child seat is properly installed. It is important for your child’s safety that you fit the belt correctly. The vehicle belt must be fixed along the red markings/ positioning points on the Axiss BébéConfort seat. Please also read the label on the side of the Axiss Bébé Confort seat. Never fit the belt in any way other than as shown. IMPORTANT: After you have finished installing your child restraint seat, check the following points and correct as required. IMPORTANT: when the child is seated in the Axiss seat, the seat must be locked in the forward-facing position before setting off. iMPORTANT: The belt is securely fastened and is not twisted. ATTENTION : pour faciliter le verrouillage de l’assise (témoin vert) dans certains véhicules, il peut être nécessaire d’exercer une pression en haut de l’assise WARNING : to enable the seat to lock into position (green indicator), in some vehicles it may be necessary to exert pressure on the top of the seat. If the seat is not stable: •  djust the height of your vehicle’s head rest. The head A rest must never be in contact with the Axiss seat. € f possible and if necessary, adjust the angle of your I vehicle seat to ensure it is in contact with the base. If you are finding it hard to swivel the seat or to secure the seat in the forward-facing position (green indicator). € Check the fitting: • The seatbelt must pass through all the strap guides, • There should be no slack in the lap section of the seatbelt, •  ake sure no part of the seatbelt is in contact with a M movable part of the seat, • Is the seatbelt fastened too tightly? [. . . ] We confirm that this product was manufactured in accordance with the current European safety requirements and quality standards which are applicable to this product, and that this product is free from defects on materials and workmanship at the time of purchase. Our 24 months warranty covers all manufacturing defects in materials and workmanship when used in normal conditions and in accordance with our user manual. To request repairs or spare parts under warranty for defects in materials and workmanship you must present your proof of purchase, made within the 24 months preceding the service request. Our 24 months warranty does not cover damage caused by normal wear and tear, accidents, abusive use, negligence or the consequence of failing to comply with the user manual. [. . . ]