User manual BEGLEC IROCK 7S-7B VERSION 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Thank you for buying this JB Systems product. [. . . ] Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb with bare hands! this drastically shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Be sure that the wires don't touch the lamp. Close the lamp compartment with the screws. Turn on the unit and point the beam to a white surface. Use the three adjustment screws indicated by "lamp adjust". Gently turn these three screws until you obtain maximum light output. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ] Its DMX input will have nothing plugged into it, and its master-LED will be constantly on and sound-LED will flash to the music. This function only works when the blackout mode in the menu of the master is set to OFF, otherwise nothing will happen!Read more about this option in the "Main Menu" paragraph. SLAVES have 2 working options: The other units are set to slave mode (slaveLED is constantly on). [. . . ]