User manual BEHRINGER BEAT800

[. . . ] MINIBEAT BEAT800 Users manual Version 1. 0 October 2005 MINIBEAT BEAT800 IMPORTANT SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] 6 MINIBEAT BEAT800 1. 1. 2 Initial operation + Be sure that there is enough space around the unit for cooling. To avoid overheating, do not place the BEAT800 on top of power amps or near radiators, etc. To power the BEAT800, use only the power supply unit that is delivered with your equipment. 1. 1. 3 Online registration Please do remember to register your new BEHRINGER equipment right after your purchase by visiting www. behringer. com (alternatively www. behringer. de) and kindly read the terms and conditions of our warranty carefully. Should your BEHRINGER product malfunction, our goal is to have it repaired as quickly as possible. To arrange for warranty service, please contact the retailer from whom the equipment was purchased. Should your BEHRINGER dealer not be located in your vicinity, you may directly contact one of our subsidiaries. Corresponding contact information is included in the original equipment packaging (Global Contact Information/European Contact Information). Should your country not be listed, please contact the distributor nearest you. A list of distributors can be found in the support area of our website (www. behringer. com/support). Registering your purchase and equipment with us helps us process your repair claims quicker and more efficiently. CONTROL ELEMENTS AND CONNECTIONS + Please ensure that the unit is installed and operated only by people qualified to do so. During installation and operation the user must have sufficient electrical contact to earth. Electrostatic discharge may affect the operation of the unit. 2. 1 The front Fig. 2. 1: Front panel control elements of the BEAT800 switch The switch turns your MINIBEAT BEAT800 on and off. + Attention: The switch does not fully disconnect the unit from the mains. To disconnect the unit from the mains, pull out the main cord plug or appliance coupler. When installing the product, ensure the plug or appliance coupler is readily operable. Unplug the power cord completely when the unit is not used for prolonged periods of time. 6 2. CONTROL ELEMENTS AND CONNECTIONS LED display The LED display is for monitoring the input level. If the Clip LED lights up, BEAT800 input might be distorted. In this case, reduce the input level. MINIBEAT BEAT800 Display The 3-digit display of the BEAT800 shows the tempos of the incoming signals, expressed in BPM (Beats Per Minute). The left display shows the signal that enters CHANNEL A. [. . . ] Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyers expense. BEHRINGER will inform the buyer of any such circumstance. [. . . ]