User manual BEHRINGER BX3000T

[. . . ] BX3000T Users Manual Version 1. 1 October 2003 ULTRABASS ENGLISH ULTRABASS BX3000T IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 7) Do not block any ventilation openings. [. . . ] Use the OUTPUT control to determine the overall volume of your BX3000T. When the built-in limiter is activated, the LED below the OUTPUT control lights up. Connect the SEND/TUNER output to the input of your effects device, for example, our proven multi-effects processor BEHRINGER VIRTUALIZER PRO DSP2024P. This output can also be used to connect your tuner. Connect the RETURN jack to the output of your effects device. Since the BX3000T features a serial effects path, the mix ratio must be set on your effects device. XLR output to feed the audio signal from your ULTRABASS to an external mixing console. Use the LINE OUT jack to connect your BX3000T to a mixing console that has no balanced inputs and/or to provide a signal that is independent of all settings adjusted on the BX3000T. The LINE OUT output is wired post effects loop & and can also be used to feed the output signal of your BX3000T to an external bass amp. + Fig. 2. 2: BX3000T front panel (section 2) + 6 2. CONTROL ELEMENTS 2. 2 Rear panel + ULTRABASS BX3000T For correct speaker connection please also refer to chapters 3. 3, 3. 3. 1 and 6. 2. 1! 3. WIRING EXAMPLES This chapter is aimed at describing and illustrating basic wiring examples. 3. 1 Standard setup comprising footswitch and one loudspeaker The standard setup is intended for rehearsals, sessions and club gigs. Fig. 2. 4: BX3000T rear panel (section 1) Use the POWER switch to switch the BX3000T on or off. You should always make sure that the POWER switch is in the Off position when initially connecting the unit to the mains. To disconnect the unit from the mains, pull out the main cord plug. When installing the product, ensure that the plug is easily accessible. If mounting in a rack, ensure that the mains can be easily disconnected by a plug or by an all-pole disconnect switch on or near the rack. Please note: Merely switching the unit off does not mean that it is fully disconnected from the mains. When not using the unit for prolonged periods of time, please unplug the units power cord from the power outlet. Use the power cord supplied with the unit to connect it to the mains. Before connecting the unit to the mains, make sure that the voltage setting matches your local voltage. A blown fuse should only be replaced by a fuse of the same type and rating. [. . . ] Damages/defects caused by the following conditions are not covered by this warranty: s improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. s connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. s damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. [. . . ]