User manual BEHRINGER BX4210A

[. . . ] BX4210A/BX4210 Users manual Version 1. 2 June 2006 ULTRABASS ULTRABASS BX4210A/BX4210 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 5) Do not use this apparatus near water. [. . . ] 2. 3: BX4210A/BX4210 front panel (section 3) When you enable the SHAPE filter with switch , you can use the SHAPE control to modify the filter sound. The filter position is adjustable in the range from 120 Hz 1. 2 kHz. The SHAPE switch activates the SHAPE filter. When the filter is on, the LED above the switch lights up. Use the OUTPUT control to determine the overall volume of your BX4210A/BX4210. + 2. CONTROL ELEMENTS 5 ULTRABASS BX4210A/BX4210 + When the built-in limiter is activated, the LED below the OUTPUT control lights up. Connect the SEND/TUNER output to the input of your effects device, for example, our proven multi-effects processor BEHRINGER VIRTUALIZER PRO DSP2024P. This output can also be used to connect your tuner. Connect the RETURN jack to the output of your effects device. Since the BX4210A/BX4210 features a serial effects path, the mix ratio must be set on your effects device. XLR output to feed the audio signal from your ULTRABASS to an external mixing console. Use the LINE OUT jack to connect your BX4210A/BX4210 to a mixing console that has no balanced inputs and/or to provide a signal that is independent of all settings adjusted on the BX4210A/BX4210. The LINE OUT output is wired post effects loop & and can also be used to feed the output signal of your BX4210A/BX4210 to an external bass amp. 2. 5: BX4210A/BX4210 rear panel (section 2) The intern speakers of the BX4210A/BX4210 are connected to the 1/4" SPEAKER output jacks. They can also be used to connect external loudspeakers. For further speaker connection you find a professional loudspeaker connector (compatible to Neutrik® Speakon®). Your speaker cabinets should have a sufficient power rating (>450 W) and preferably a total impedance of 4 W to avoid speaker damage. Too high a load impedance will decrease the output power rating of the power stage!For correct speaker connection please also refer to chapters 3. 3, 3. 3. 1 and 6. 2. 1! + + 2. 2 Rear panel + 3. WIRING EXAMPLES This chapter is aimed at describing and illustrating basic wiring examples. 3. 1 Standard setup comprising footswitch and external loudspeaker 21 22 23 24 Fig. 2. 4: BX4210A/BX4210 rear panel (section 1) Use the POWER switch to switch the BX4210A/BX4210 on or off. You should always make sure that the POWER switch is in the Off position when initially connecting the unit to the mains. [. . . ] If the buyer fails to submit a written repair order within 6 weeks after notification, BEHRINGER will return the unit C. O. D. with a separate invoice for freight and packing. Such costs will also be invoiced separately when the buyer has sent in a written repair order. § 4 RETURN AUTHORIZATION NUMBER 1. To obtain warranty service, the buyer (or his authorized dealer) must call BEHRINGER (see enclosed list) during normal business hours BEFORE returning the product. [. . . ]