User manual BEHRINGER CX2310

[. . . ] CX2310 Users Manual Version 1. 0 March 2001 SUPER-X PRO ® www. behringer. com ENGLISH SUPER-X PRO CX2310 SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosurevoltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. [. . . ] This control governs the crossover frequency between the mid and high bands. This is used to control the output level of the mid band over the range -6 to +6 dB. This reverses the polarity of the mid output. This controls the output level of the high band over the range from -6 to +6 dB. This reverses the polarity of the high output. This control governs the crossover frequency between the low signal and the subwoofer signal. This sets the subwoofer output volume level at the SUBW. OUT output. This switch is used to reverse the polarity of the subwoofer output signal. This is used to mute the subwoofer output signal. 8 2. CONTROL ELEMENTS SUPER-X PRO CX2310 Fig. 2. 4: Active control elements and connections on the rear panel of the SUPER-X PRO in mono 3-way operation with separate subwoofer signal 1 2 3 4 5 6 7 HIGH OUTPUT connector. This is the balanced XLR connector for the high output signal. This is the balanced XLR connector for the mid output signal. This is the balanced XLR connector for the low output signal. This is used to switch between the control ranges of the front panel MID/HIGH XOVER FREQ. The range is either 44 to 930 Hz or 440 Hz to 9. 3 kHz. This is used to switch between the control ranges of the front panel LOW/MID XOVER FREQ. The range is either 44 to 930 Hz or 440 Hz to 9. 3 kHz. This is the balanced XLR connector for the input signal. This must be de-activated when in mono 3-way operation. switches without having first switched off the equipment. Switching between these whilst the equipment is in use produces heavy interference noise which could damage the loudspeakers or the system. [. . . ] This also applies to defects caused by normal wear and tear, in particular, of faders, potentiometers, keys/buttons and similar parts. Damages/defects caused by the following conditions are not covered by this warranty: s misuse, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. s connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. s damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. [. . . ]