User manual BEHRINGER DDM4000

[. . . ] DDM4000 User Manual A50-16713-00001 DIGITAL PRO MIXER DIGITAL PRO MIXER DDM4000 Important Safety Instructions 1) Read these instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. Caution + To reduce the risk of electric shock, do not remove the top cover (or the rear section). + To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. [. . . ] Eight different types of reverberation are available. These are described in detail in Chapter 4. 1. 4. 1) Press the CONSOLE SETUP knob [51] to select a parameter. 2) Turn the CONSOLE SETUP knob to change the value of this parameter. You can match the time parameter of the flanger, phaser, delay and echo effects to the beat by tapping the tempo with the left TAP push button (50) as long as Mic Setup is displayed (MIC SETUP push button [16] shines when active). Exiting Mic Setup: = Press the ESC push button [52] to exit Mic Setup. MIC1 LOW CUT: MIC FX page: On the Mic FX page, you can select the type of effect you want to use for the microphone signal. The following effects are available: The Ultramic processor is a 2-band compressor that reduces the dynamic range of speech. The level of loud sounds is reduced and the level of quiet sounds is raised. This decreases the difference between the loudest and quietest passages. By splitting the signal into two frequency bands, a thicker, more powerful sound is achieved without the typical artifacts, such as pumping sound or a loss of clarity. The settings for both microphone signals are made separately. That's the reason for having two Ultramic pages. For Mic 1, select the page "Ultramic 1" and choose "Ultramic 2" for Mic 2. The parameters on both pages are identical so that they only have to be described once. You can see several level meters on the display. Three parameters of the compressor are adjustable plus you can also load presets. The meters: MIC I Shows the input level MIC 0 Shows the output level COM Shows the compression ratio for the low (L) and high (H) frequency band EXP Shows the attenuation of the expander for the low (L) or high (H) frequency band Adjustable parameters THRSH Threshold specifies the cutoff frequency of the Ultramic processor FREQ Adjusts the crossover frequency between the upper and lower frequency band EFFIC Efficiency: Adjusts the level of compression 1) Press the CONSOLE SETUP knob [51] to select the parameter (THRSH, FREQ, EFFIC). 2) Turn the CONSOLE SETUP knob to change the value of the selected parameter. Ultramic presets: The following default settings can be loaded: 1) Turn the right PARAMETER knob [45] to select the preset. 2) Press the PARAMETER knob to load the preset. Operation 15 DIGITAL PRO MIXER DDM4000 3. 3. 2 Talk Setup The Talkover function is useful when making announcements while the music is playing. The level of the music, is attenuated as soon as you speak into the microphone. [. . . ] = damage/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. [. . . ]