User manual BEHRINGER DR400

[. . . ] CONTROLS Top view Select the effect mode via the MODE switch (see table below). Depending on the selected mode, this knob adjusts the reverb time or the delay time. In REVERB mode, this knob adjusts the reverbs' tonal character. In DELAY and DLY+REV mode, this knob adjusts the amount of feedback (number of repetitions). 1 2 3 4 5 6 7 8 9 10 11 Effect description Short delay (32 - 128 ms) Medium delay (128 - 500 ms) Long delay (500 - 2000 ms) Delay+small room (32 - 2000 ms) Delay+big room (32 - 2000 ms) Delay+concert hall (32 - 2000 ms) Delay+reverb plate (32 - 2000 ms) Simulates the reverb of a small room Simulates the reverb of a big room Simulates the reverb of a concert hall Simulates the sound of a reverb plate Delay time Delay time Delay time Delay time Delay time Delay time Delay time Reverb time Reverb time Reverb time Reverb time Feedback Feedback Feedback Feedback Feedback Feedback Feedback Tone Tone Tone Tone DLY+REV DELAY REVERB The BALANCE control determines the balance between the direct (dry instrument) signal and the effect sound. [. . . ] Disconnect the plug, if you don't use the DR400. In doing so, you can extend the life time of the battery. The SERIAL NUMBER is located on the underside. In rare cases interferences of the normal function may appear by external influence (e. g. electrostatic discharge), as for example sound disturbances or malfunctions. If this occurs, please turn down the volume on subsequent amplifiers and disconnect the input connector briefly to restart the application. 2. WARRANTY For our current warranty terms, please refer to our website at http://www. behringer. com. 3. SPECIFICATIONS IN OUT A / OUT B Power supply Connector ¼" TS; 500 kOhm Connector ¼" TS; 1 kOhm 9 V_, 100 mA regulated BEHRINGER PSU-SB USA/Canada 120 V~, 60 Hz China/Korea 220 V~, 50/60 Hz Europe/Australia 230 V~, 50 Hz Japan 100 V~, 50/60 Hz 2 mm DC jack, center negative 9 V type 6LR61 65 mA approx. 54 mm (2 1/8") x 70 mm (2 3/4") x 123 mm (4 4/5") approx. 0. 33 kg (0. 73 lbs) Power connector Battery Power consumption Dimensions (H x W x D) Weight BEHRINGER is constantly striving to maintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice. Specifications and appearance may therefore differ from those listed or shown. 4. SAFETY INSTRUCTIONS Do not use near water, nor install near heat sources. Use only authorized attachments/accessories. Contact our qualified servicing personnel for servicing or repairs, especially when power supply cord or plug is damaged. Betreibe das Gerät nicht in der Nähe von Wasser oder Wärmequellen. Verwende bitte nur autorisiertes Zubehör. Führe bitte keinerlei Reparaturen am Gerät eigenständig durch. Reparaturen sind nur von qualifiziertem Fachpersonal vorzunehmen, insbesondere bei Beschädigungen des Netzkabels oder Netzsteckers. Ne pas utiliser ni installer à proximité de liquides ou de sources de chaleur. [. . . ] Products are sold through our authorized dealers only. Distributors and dealers are not agents of BEHRINGER and have absolutely no authority to bind BEHRINGER by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER International GmbH. © 2007 BEHRINGER International GmbH. [. . . ]