User manual BEHRINGER DSP1000P

[. . . ] DSP1000P User´s Manual Bedienungsanleitung Version 1. 0 October 1998 E D VIRTUALIZER PRO ® www. behringer. de 1 EG-Declaration of Conformity INTERNATIONAL GmbH acc. to the Directives 89/336/EWG and 73/23/EWG We, BEHRINGER INTERNATIONAL GmbH Hanns-Martin-Schleyer-Straße 36 - 38 D - 47877 Willich Name and address of the manufacturer or the introducer of the product on the market who is established in the EC herewith take the sole responsibility to confirm that the product: VIRTUALIZER PRO DSP1000P Type designation and, if applicable, Article-No which refers to this declaration, is in accordance with the following standards or standardized documents: x EN 60065 x EN 55020 x EN 55013 x EN 61000-3-2 x EN 61000-3-3 x EN 55022 The following operation conditions and installation arrangements have to be presumed: acc. Nier, President Name, address, date and legally binding signature of the person responsible Willich, 01. 10. 1998 2 SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electrical shock, do not remove the cover (or back). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture. [. . . ] Whenever youre editing a preset, the display starts flashing to indicate that the edits will be saved only when you confirm them by pressing the STORE key twice. Example: s You recall a program for editing. Then you edit the preset as desired using the function keys and the jog wheel. During this process, the flashing STORE key reminds you that the preset settings have been changed but not saved yet. The display reads the current preset number and starts flashing. To keep the original preset, use the jog wheel to select another preset that can be overwritten. Press the STORE key again to save the changes to the selected preset. If you wish to overwrite the original preset, simply press the STORE key twice (after editing) to save all changes you have made. + Whenever you have edited a preset and pressed the STORE key twice, all previous settings in this preset are erased and overwritten with the new parameter values. However, if you wish to keep the original preset, use the jog wheel to select another preset before you press the STORE key a second time. 2. 5 MIDI control Use the MIDI key combination to select the MIDI parameters you wish to adjust. For this purpose, keep the IN/OUT and the STORE keys pressed for about two seconds. All parameters can be edited with the jog wheel and the IN/OUT key. The MIDI menu includes five pages which you can select by pressing the IN/OUT key several times. On the first page you can select the MIDI channel. The display shows a small c (= channel). The jog wheel adjusts a channel from 1 through 16. To switch off the MIDI function, simply select the 0 value (displayed as -). On the second page you can select MIDI Omni mode, i. e. the unit transmits/receives on all 16 MIDI channels. Use the jog wheel to activate (1) or deactivate (0) Omni mode. The third page allows for configuring controller commands. On its right-hand side, the display shows a capital C (=Controller). The jog wheel selects one of the following four controller modes: 2. [. . . ] Damages/defects caused by the following conditions are not covered by this warranty: s misuse, neglect or failure to operate the unit in compliance with the instructions given in the user or service manuals. s connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. s damages/defects that are caused by force majeure or by any other condition beyond the control of BEHRINGER INTERNATIONAL. Any repair carried out by unauthorized personnel will void the warranty. [. . . ]