User manual BEHRINGER E1520A

[. . . ] E1220A/E1520A User manual A50-71533-00001 EUROLIVE EUROLIVE E1220A/E1520A Important safety instructions 1) Read these instructions. 5) Do not use this apparatus near water. 7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. [. . . ] + Please dispose of all packaging materials in an environmentally friendly fashion. Uli Behringer 4 Introduction EUROLIVE E1220A/E1520A 1. 1. 2 Initial operation Be sure that there is enough space around the unit for cooling. To avoid overheating, do not place the E1220A/E1520A on top of power amps or near radiators, etc. + Blown fuses must be replaced by fuses of the same type and rating. Please refer to the "SPECIFICATIONS" for further details. The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all international safety certification requirements. + Please make sure that all equipment is properly grounded at all times. For your own safety, never remove or disable the ground conductor of the unit or of the AC power cord. + The sound quality may diminish within the range of powerful broadcasting stations and high-frequency sources. Increase the distance between the transmitter and the device and use shielded cables for all connections. 2. Control elements and connections Warning + This loudspeaker is capable of producing extreme volumes. Please keep in mind that high sound pressures do not only temporarily damage your sense of hearing, but can also cause permanent hearing damage. Be careful to select a suitable volume at all times. Fig. 2. 1: Control elements and connections (E1220A and E1520A) {1} Use this 1/4" stereo jack to connect a signal source that has 1/4" output. {2} Use this XLR connector to connect a signal source that has XLR output. + Always use either the XLR or the 1/4" jack input, and use the LEVEL control {4} to adapt the input sensitivity. {3} The LINK OUTPUT is directly connected to the inputs of the E1220A/E1520A and carries the input signal with no processing applied. In this way, you can route the signal to the input of another device (for example, a second E1220A/E1520A). {4} To set the volume of the LINE or MIC signal, use the LEVEL control. The left half of the control range is for attenuating the LINE signal. The right half is for raising the level of the MIC signal. {5} The CLIP LED lights up when signal distortion occurs. [. . . ] This also applies to defects caused by normal wear and tear, in particular, of faders, crossfaders, potentiometers, keys/buttons, tubes, guitar strings, illuminants and similar parts. Damages/defects caused by the following conditions are not covered by this warranty: = improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. = connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. = damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. [. . . ]