User manual BEHRINGER EG8080

[. . . ] EUROGRAND EG8080-BK User's manual Version 1. 1 August 2006 K1800FX EUROGRAND EG8080-BK IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 13) Only use attachments/accessories specified by the manufacturer. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). [. . . ] All data recorded up to this point will be stored, but the recording process will be terminated. 7) Once your recording is finished stop the sequencer by pressing the START/STOP button again. 14 6. ADVANCED OPERATION EUROGRAND EG8080-BK Recording mode automatically. will thus be canceled 8) Repeat the whole procedure to record a second track. This time, however, select TRACK 2 instead of TRACK 1 in step #3. TIP: If the right-hand part of a music piece you want to practice has been recorded on track 2 and the left-hand part on track 1 (for example, by your piano teacher), you can mute one of the two tracks during playback to practice the corresponding part. TIP: Press the METRONOME button again to stop the metronome click. ATTENTION: If you select a track for recording, which already contains note information, all previously recorded notes on this track will be erased!4) Select a sound in the SOUND SELECT section. You can also use a sound combination (see chapter 5. 1) for recording. 6. 5. 2 Editing pieces of music This section describes how to edit a recording by replacing a recorded track with a new recording. What is more, you can see how to record a track without playing back the second track, which can be useful when you record two different pieces of music. You must have recorded at least one track before you can carry out the steps described below. If you are not sure whether a track has been recorded or not, check this by pressing the TRACK 1 and TRACK 2 button, BEFORE you enter record mode. If one of the PLAY LEDs above the TRACK buttons light up, this shows you that something has been recorded on this track. 1) If you do not want to hear the previously recorded track while you record the second one, press the TRACK button of the track until its green PLAY LED goes out. If you want to hear the previously recorded track, continue with step #2. 5) Switch on the acoustic metronome signal by pressing the METRONOME button, if you want to make a metronomebacked recording. 6) Start recording by pressing the START/STOP button or simply start playing on the keyboard. The current meter is constantly shown in the display. If the display starts flashing during recording and reads the message FUL, this is to warn you that the recording memory has been used up. All data recorded up to this point will be stored, however, but recording process will be terminated. The REC LED above the TRACK 1 or TRACK 2 button lights up. The dots on the display start flashing in the metronome tempo that has been set, thus indicating the beat. 7) Once your recording is finished stop the sequencer by pressing the START/STOP button again. The memory of the music sequencer can store up to 10, 000 notes. However, this number can decrease depending on how much pedaling information is stored. [. . . ] damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. [. . . ]