User manual BEHRINGER PMH3000

[. . . ] EUROPOWER PMH1000/PMH3000/PMH5000 ENGLISH User's Manual Version 1. 2 November 2004 EUROPOWER PMH1000/PMH3000/PMH5000 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. 5) Do not use this apparatus near water. 7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. [. . . ] In this way, you can monitor one or several selected signals via the PHONES/ CTRL jack . When AFL is on, the corresponding control LED illuminates. The PMH1000 does not have an AFL function. This is the master send fader for the signal routed to the effects processor and to the FX SEND output (see also and ). 6 2. CONTROL ELEMENTS EUROPOWER PMH1000/PMH3000/PMH5000 PMH1000: MON SEND fader. These faders are used to set the monitor output volume (see also and ). PMH1000: The main mix allows you to control the volume from the Main 1 output with both faders. PMH3000/PMH5000: The MAIN 1 fader controls the volume of the EUROPOWER. The main signal is also provided at the MAIN 1 output (see also ). PMH3000/PMH5000: The MONO fader controls the mono mix signal (see also ). PMH5000: The SUB FILTER filters out frequencies above the selected setting, so that only low frequencies are sent to an (active) subwoofer via the MONO OUT ). Set this switch to "On" to activate the filter. PMH5000: The SUB FREQ control determines the cut-off frequency for the subwoofer output. This value can be adjusted from 30 to 200 Hz. The PHONS/CTRL R control adjusts the headphone or control room volume (see also ). PMH3000/PMH5000: The MAIN 2 control determines the volume at the MAIN 2 output (see also ), which is the same signal as at MAIN 1, but with extra output jacks and separate volume control. PMH3000/PMH5000: With the CD/TAPE IN control you can adjust the volume of the line signal present at the CD/TAPE INPUT . Use the PFL switch to monitor the signal. PMH1000: With the CD/TAPE RET fader you can adjust the line signal applied to the CD/TAPE INPUT . Use the CD/TAPE MUTE switch to mute the channel. Use the SUB FILTER control to adjust the frequency. The FX SEND connector can be used to route the FX SEND signal from the input channel, for example, to the input of an external effects device. [. . . ] If the buyer fails to submit a written repair order within 6 weeks after notification, BEHRINGER will return the unit C. O. D. with a separate invoice for freight and packing. Such costs will also be invoiced separately when the buyer has sent in a written repair order. § 5 WARRANTY TRANSFERABILITY This warranty is extended exclusively to the original buyer (customer of retail dealer) and is not transferable to anyone who may subsequently purchase this product. [. . . ]