User manual BEHRINGER PMH518M

[. . . ] PMH518M User's Manual Version 1. 1 April 2006 EUROPOWER EUROPOWER PMH518M IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 5) Do not use this apparatus near water. [. . . ] In signal (see Use this 5-digit LED meter to control the output level of the main signal. The upper LIM LED illuminates when the internal amp protection circuit responds to output levels that are too high. The MASTER control is used to adjust the main output volume. 2. 1 Input channels The HIGH control in the EQ section governs the highfrequency range of the respective channel. The LOW control allows you too boost/cut the lowfrequency range. The FX control determines the signal level sent from each channel to the built-in effects processor. Please note that the effects processor signal will ) is set be inaudible when the FX LEVEL control ( fully counter-clockwise. The LEVEL control adjusts the channel signal level in the main mix. The CLIP LED is very useful to control the input gain. It should never be constantly illuminated (only with signal peaks). The PAD switch reduces the input sensitivity of the channel by approx. 30 dB, to connect for example line-level signals. The balanced LINE IN input (1/4" TRS) can be used for line-level signal sources, e. g. Each channel has a balanced MIC microphone input with XLR connectors. CONTROL ELEMENTS EUROPOWER PMH518M Fig. 2. 2: Rear panel control elements and connectors 2. 4 Rear panel The mains connection is on a standard IEC receptacle. An appropriate power cord is supplied with the unit. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. Please also read the information given in chapter 6 "SPECIFICATIONS". The three PARALLEL SPEAKER OUTPUTs provide the mono main signal on a Neutrik ® Speakon ®-compatible connector (pins 1+/1- and 2+/2-) and on two 1/4" TS connectors. The impedance of the loudspeaker connected must not fall below 4 . Information on how to properly connect your speaker with regard to polarity can be found on the rear of the mixer (PINOUTs). [. . . ] damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. [. . . ]