User manual BEHRINGER PMH880S

[. . . ] PMH660M/PMH880S Users Manual Version 1. 4 August 2006 EUROPOWER EUROPOWER PMH660M/PMH880S IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 5) Do not use this apparatus near water. [. . . ] You can activate an effect bypass that mutes the effects processor. Please use a dual footswitch for the PMH880S, so that you can enable/disable FX1 and FX2 independently of each other. In this case, the tip of the 1/4" plug controls FX1, and the ring FX2. The FX OUT connector is used to route the FX SEND signal from the input channels, for example, to the input of an external effects processor. The PMH880S has two FX controls per input signal (see ) and also two FX OUT connectors (FX OUT 1 and FX OUT 2). Please note: When you connect a mono plug to one of the FX OUT jacks, the signal path from the respective FX send to the built-in effects processor is interrupted. For each FX send you can either use the built-in effect or the corresponding FX OUT jack (for an external effect), but never both at the same time. When you use a stereo plug (tip and ring interconnected) you can use the built-in effects processor and the FX OUT jacks in parallel. Use the AUX IN 1/4" inputs to route an external stereo signal to the main mix. This can be the signal generated by an external effects processor. Use the left input for mono signals, which are then reproduced on both stereo sides. The PMH660S has only one mono AUX IN connector. The AUX IN control adjusts the volume of the external signal in the main mix. The 2TR IN RCA input allows you to feed in external stereo signals, e. g. from a CD player, tape deck or other line-level source. + + + 6 2. CONTROL ELEMENTS EUROPOWER PMH660M/PMH880S PMH660M: Either the main or the bridged main mono signal ). When you use a cable is provided at OUTPUT B (see with the normal pin connections (SPEAKON cable: pins 1+/1-), it is possible in MAIN/MAIN (BRIDGE) mode to take the mono main signal from this output (not bridged). Please also refer to chapter 4. 4 Loudspeaker connection. CHORUS: This effect slightly detunes the original signal. A very pleasant detune effect is created in connection with the pitch variation. The chorus effect is used often and quite extensively used for dispersing signals. The variations available range from slow to fast chorus effects. [. . . ] s damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyers expense. [. . . ]