User manual BEHRINGER PMP2000

[. . . ] PMP2000 User Manual Version 1. 2 May 2007 EUROPOWER EUROPOWER PMP2000 IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 13) Only use attachments/accessories specified by the manufacturer. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). [. . . ] This allows you to, say, use only the mixing and effect section of the PMP2000. Of course, you can also use only the left jack as a mono output. These two 1/4" TS jacks can be used to connect external signals, such as the main mix signal from an additional mixing console (pre-power amp). Here, you will find a list of all multi-effect presets available. This is the LED level meter of the effects processor. Please make sure that the clip LED lights up with signal peaks only. If it is lit constantly, this indicates that the effects processor is overdriven, which can lead to unpleasant distortion. The EFFECT display reads the currently selected preset. Turn the PROGRAM control to select the effect presets. Press the control briefly to confirm your selection. 2. CONTROL ELEMENTS 5 EUROPOWER PMP2000 2. 2 Rear panel The mains connection is on a standard IEC receptacle. An appropriate power cord is supplied with the unit. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. Use the POWER switch to put your PMP2000 into operation. The POWER switch should always be in the "Off" position when you are about to connect your unit to the mains. Attention: The POWER switch does not fully disconnect the unit from the mains. Unplug the power cord completely when the unit is not used for prolonged periods of time. This is the RIGHT/MONO MAIN loudspeaker output of your PMP2000, where you can connect the right loudspeaker of a stereo system. For this purpose, switch must be set to its upper position. If, however, you run a mono main mix (switch set to its lower position), this loudspeaker output provides the main mix signal in mono. The impedance of the loudspeaker connected here must not fall below 4 . [. . . ] § 6 WARRANTY TRANSFERABILITY This warranty is extended exclusively to the original buyer (customer of retail dealer) and is not transferable to anyone who may subsequently purchase this product. No other person (retail dealer, etc. ) shall be entitled to give any warranty promise on behalf of BEHRINGER. § 7 CLAIM FOR DAMAGES Failure of BEHRINGER to provide proper warranty service shall not entitle the buyer to claim (consequential) damages. In no event shall the liability of BEHRINGER exceed the invoiced value of the product. * Customers in the European Union please contact BEHRINGER Germany Support for further details. Technical specifications and appearance are subject to change without notice. [. . . ]