User manual BEHRINGER PMP5000

[. . . ] EUROPOWER PMP1000/PMP3000/PMP5000 User Manual Version 1. 0 November 2006 EUROPOWER PMP1000/PMP3000/PMP5000 IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 13) Only use attachments/accessories specified by the manufacturer. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). [. . . ] PMP1000: The POWER LED is illuminated when you switch the unit on. The LIM LEDs and the LED display do NOT light up when an external signal is fed in via the PWR AMP INSERT jacks . In all other operating modes, the minimum impedance of the speaker must not fall below 4 . 6 2 CONTROL ELEMENTS EUROPOWER PMP1000/PMP3000/PMP5000 2. 4 Main and monitor section The SURROUND control determines the effect intensity. This is a built-in effect, which widens the stereo panorama, thus making the sound more lively and transparent. Press the XPQ TO MAIN switch to activate this effect. Pressing the AFL switch (after-fader listening) activates the solo function. If AFL is on for the corresponding channel in the main section, you will only hear the signal from this channel. Its volume can be adjusted with the fader. Switching AFL on has no effect on the main or monitor mix, as long as you don't move the fader. In this way, you can monitor one or several selected signals via the PHONES/ CTRL jack . When AFL is on, the corresponding control LED illuminates. The PMP1000 does not have an AFL function. This is the master send fader for the signal routed to the effects processor and to the FX SEND output (see also and ). These faders are used to set the monitor output volume (see also and ). PMP1000: The main mix allows you to control the volume from the Main 1 output with both faders. PMP3000/PMP5000: The MAIN 1 fader controls the volume of the EUROPOWER. The main signal is also provided at the MAIN 1 output (see also ). PMP3000/PMP5000: The MONO fader controls the mono mix signal (see also ). PMP5000: The SUB FILTER filters out frequencies above the selected setting, so that only low frequencies are sent to an (active) subwoofer via the MONO OUT ). Set this switch to "On" to activate the filter. PMP5000: The SUB FREQ control determines the cut-off frequency for the subwoofer output. This value can be adjusted from 30 to 200 Hz. The PHONS/CTRL R control adjusts the headphone or control room volume (see also ). [. . . ] No other person (retail dealer, etc. ) shall be entitled to give any warranty promise on behalf of BEHRINGER. § 7 CLAIM FOR DAMAGES Failure of BEHRINGER to provide proper warranty service shall not entitle the buyer to claim (consequential) damages. In no event shall the liability of BEHRINGER exceed the invoiced value of the product. * Customers in the European Union please contact BEHRINGER Germany Support for further details. Technical specifications and appearance subject to change without notice. The information contained herein is correct at the time of printing. [. . . ]