User manual BEHRINGER PMP860M

[. . . ] PMP860M/PMP880S/PMP1280S User manual Version 1. 1 November 2006 EUROPOWER EUROPOWER PMP860M/PMP880S/PMP1280S IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 13) Only use attachments/accessories specified by the manufacturer. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). [. . . ] Please note: The POWER switch does not fully disconnect the unit from the mains. Unplug the power cord completely when the unit is not used for prolonged periods of time. + + In BRIDGE mode, always connect only one loudspeaker with an impedance of at least 8 W to OUTPUT B (pins 1+/2+)!Please note that OUTPUT A must NEVER be used in BRIDGE mode (with pin connections 1+/2+)!In all other operating modes, the minimum impedance of the speaker connected must not fall below 4 W. Use the SPEAKER PROCESSING switch to activate a filter that adapts the mixer to the specifications of your loudspeakers. If the speakers have a limited frequency response in the bass range, it allows you to adapt it optimally to the frequency response of the speakers. If STANDBY is pressed, all input channels are muted. During breaks you can thus prevent the microphones from picking up noise or interference, which would then be reproduced by the P. A. The advantage is that all faders can be left untouched while you play a CD via the CD/TAPE inputs (see ). There is also no need to move down the faders of muted channels and lose your mix. + + 2. 4 Rear panel The mains connection is on a standard IEC receptacle. An appropriate power cord is supplied with the unit. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. Please also read the information given in chapter 6 SPECIFICATIONS. PMP880S/PMP1280S: Depending on the operating mode selected (see ) either the left main signal or the monitor signal is provided at OUTPUT A. NEVER use this output in bridged mono mode. PMP860M: In MON/MAIN mode, the monitor signal is provided at OUTPUT A (see ). NEVER use this output in bridged mono mode, except when you use a cable with the normal pin connections (pins 1+/1-). In this case you can take the mono main signal from this output in MAIN/MAIN (BRIDGE) mode (not bridged). Please also refer to chapter 4. 3 Loudspeaker connection. The impedance of the loudspeaker connected must not fall below 4 W. Please note that the power delivered to the speaker in bridged mono mode is considerably higher than in other operating modes. [. . . ] 7 CLAIM FOR DAMAGES Failure of BEHRINGER to provide proper warranty service shall not entitle the buyer to claim (consequential) damages. In no event shall the liability of BEHRINGER exceed the invoiced value of the product. * Customers in the European Union please contact BEHRINGER Germany Support for further details. Technical specifications and appearance subject to change without notice. The information contained herein is correct at the time of printing. The names of companies, institutions or publications pictured or mentioned and their respective logos are registered trademarks of their respective owners. [. . . ]