User manual BEHRINGER RX1202FX

[. . . ] EURORACK PRO RX1202FX User's Manual Version 1. 0 February 2006 DEUTSCH EURORACK PRO RX1202FX IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 5) Do not use this apparatus near water. [. . . ] Recording: For mastering, using a stereo compressor such as the COMPOSER PRO-XL MDX2600 can be recommended. Use it to custom-tailor the dynamic characteristics of your signal to the dynamic range of the recording equipment you are using. The signal is in this case passed on from the compressor into the recorder. CTRL OUT The CTRL OUT connectors are used for controlling the summed signal (effects mix and main mix) as well as for individual signals over studio monitor speakers. By using the PHONES/CONTROL ROOM controller in the main section, you can control the level of both outputs. CD/TAPE IN The CD/TAPE INs are used to bring an external signal source (e. g. CD player, tape deck, etc. ) into the console. They can also be used as a standard stereo line input, so the output of a second EURORACK or BEHRINGER ULTRALINK PRO MX882 can be connected. Alternatively, the line or tape output of a hi-fi amplifier with source selection switch could also be hooked up here, allowing you to easily listen to additional sources (e. g. cassette recorder, minidisk player, sound card etc. ). 8 2. CONTROL ELEMENTS AND CONNECTORS EURORACK PRO RX1202FX 2. 4 Main section When recording to an analog device, the VU meters of the recording machine should reach approx. Due to their inertia VU meters tend to display too low a signal level at frequencies above 1 kHz. This is why, for example, a Hi-Hat should only be driven as far as -10 dB. The CLIP LEDs of your EURORACK display the level virtually independent of frequency. A recording level of 0 dB is recommended for all signal types. MAIN MIX Use the MAIN MIX fader to adjust the volume of the main out. PHONES The connector is used to connect a pair of headphones. The volume level is changed with the PHONES/CONTROL ROOM controller. PHONES/CONTROL ROOM Use the PHONES/CONTROL ROOM control to adjust the signal level of the CTRL OUT and PHONES outputs. FX SOLO If you want to only listen to the effects signal with your headphones or monitor speakers, then press the FX SOLO switch. The signal of the effects device can then be heard individually; the main mix or CD/tape signal is inaudible at the PHONES and CTRL OUT outputs. CD/TAPE TO CTRL Press the CD/TAPE TO CTRL switch if you want to monitor the CD/TAPE IN via the CTRL OUT and PHONES outputs. [. . . ] damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. [. . . ]