User manual BEHRINGER RX1602

[. . . ] RX1602 Users Manual VERSION 1. 4 December 2003 Version 1. 3 November 2003 EURORACK PRO ENGLISH EURORACK PRO RX1602 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 7) Do not block any ventilation openings. [. . . ] With analog recorders, the VU meters of the recording device should read roughly up to +3 dB in case of low-frequency signals (e. g. Because of their inherent inertia, VU meters tend to display levels of signals with frequencies of above 1 kHz too low. Therefore, when using instruments such as a hi-hat, you should set the input gain only up to -10 dB. Snare drums should be set up to roughly 0 dB. Fig. 2. 4: MAIN OUT and MON OUT SEND connectors The MAIN OUT connectors come as 1/4" TRS jacks. The main mix signal (derived from all channels) is present here. You can set the output signal level by using the MAIN LEFT and MAIN RIGHT controls (reducing all the way down to -oo, increasing up to +15 dB). The main mix signal can be used to feed your mixing console or stereo amplifier, among others. The monitor signal can be taken at the MON OUT SEND connector (1/4" TRS connector). It is just as well-suited for being used with effects applications. 2. 3 Mains connection + The peak meters of your EURORACK PRO display the level virtually frequency-independent. A recording level of 0 dB is recommended for all kinds of signals. The TO PHONES switch gives you the option to feed the signals routed to the monitor/effects bus into your headphones for control purposes. + ATTENTION! We would like to bring your attention to the fact that high volume levels may damage your hearing and/ or your headphones. Please turn the MAIN LEFT and MAIN RIGHT controls as well as the PHONES control in the main section all the way to the left before powering up the unit. Please always pay keen attention to an appropriate volume level. 2. 5: Mains connector with integrated fuse compartment The mains connection is achieved via the standard IEC connector. A matching power cord is included. 6 2. CONTROL ELEMENTS AND CONNECTIONS EURORACK PRO RX1602 FUSE COMPARTMENT/VOLTAGE SELECTION: Before plugging the unit into a power socket, please make sure you have selected the correct voltage. Faulty fuses must be replaced with fuses of appropriate rating without exception. Some units feature a fuse compartment that can be operated in two different positions, allowing alternating between 230 V and 120 V. Attention: when using the unit outside of Europe (running on 120 V), you have to implement a fuse with a higher rating. The serial number is located on the top of the unit. Please take a few minutes and send to us a completely filled out warranty card within 14 days of the original date of purchase. [. . . ] Products which do not meet the terms of this warranty will be repaired exclusively at the buyers expense. BEHRINGER will inform the buyer of any such circumstance. If the buyer fails to submit a written repair order within 6 weeks after notification, BEHRINGER will return the unit C. O. D. with a separate invoice for freight and packing. [. . . ]