User manual BEHRINGER UP1200

[. . . ] UP1200 User Manual A50-83433-00001 ULTRAPAR ULTRAPAR UP1200 Safety instructions CAUTION To reduce the risk of electrical shock, disconnect the spotlight from the mains before cleaning or servicing the unit. No user serviceable parts inside; refer servicing to qualified personnel. WARNING To reduce the risk of fire or electrical shock, do not expose the spotlight to rain or moisture. Detailed safety instructions: 1) 2) 3) 4) 5) 6) 7) 8) 9) Read these instructions. Install in accordance with the manufacturer's instructions. [. . . ] The entire bottom side of the lamp socket must be in contact with the casing. = Remount the casing and connect it to the grounding cable {2} coming from the spotlight. Fasten the thumb screw until the casing is safely mounted in place. = Avoid touching the reflector with bare hands. Oily finger marks can bake onto the glass surface and substantially lower optical quality. 3. Lenses Your ULTRAPAR spotlight is delivered with four glass lenses. + Never use your ULTRAPAR without the protective mesh in combination with the color frame because it prevents direct contact with the hot lamp surface. It also prevents pieces of broken glass from uncontrollably dispersing in the event of the lens being broken. The shape of each lens determines the light beam produced by the spotlight (Fig. Also, use the turnable lens ring to optimally adjust the direction of the light beam. Name Narrow-spot lens Spot lens Medium flood lens Wide medium flood lens Quality Transparent glass Grain screen glass Glass with few facets Glass with many facets Properties Round beam (15°) Round, slightly diffuse beam (19°) Oblong beam (21° x 34°) Oblong beam (30° x 51°) Fig. 3. 1: ULTRAPAR lenses and their features + Defective lenses (scratches, cracks, etc. ) must be replaced immediately. Lenses 5 ULTRAPAR UP1200 3. 1 Dismounting the lens + The lens gets very hot during operation of the spotlight, so let it cool down sufficiently before you attempt to dismount it!= Disconnect the spotlight from the mains and wait until it has cooled down. = Place the spotlight on a flat and stable surface. Never mount or dismount the lens, while the spotlight is fixed to a truss or stand. = Remove the protective mesh {8}: press its two spring shackles, then pull out the mesh. = Directly in front of the lens, you will find a movable metal clamp {4} attached to the lens ring {5}. Turn the lens ring, until the metal clamp is located on the top side of the spotlight (directly below the locking bracket [13]). = Tilt the front side of the spotlight forward by at least 45°. = Push the movable metal clamp upward to dismount and pull out the lens [10]. 3. 2 Mounting the lens = Tilt the spotlight forward and turn the lens ring {5}, until the movable metal clamp {4} is located on the top side of the spotlight (directly below the locking bracket [13]). = Insert the lens with its rounded side towards the rear. The lower edge of the lens must be located behind the projecting elements {6} of the lens ring. [. . . ] = damage/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. 3. 4. 5. 6. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyer's expense. [. . . ]