User manual BEHRINGER VT15FX

[. . . ] VIRTUBE VT30FX/VT15FX/VT15CD User Manual A50-45633-00004 VIRTUBE VT30FX/VT15FX/VT15CD Important Safety Instructions 1) Read these instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. Caution + To reduce the risk of electric shock, do not remove the top cover (or the rear section). + To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. [. . . ] + With too high a volume level some headphones tend to produce distortion. Please turn down the volume a bit, until distortion stops. [18] Use the FOOTSWITCH jack to connect the 1/4" TRS plug of the footswitch supplied with the unit. The footswitch performs a dual function: it switches between the two channels and turns the FX on and off (VT30FX only). [19] The POWER switch turns your VIRTUBE on and off. It should always be in the OFF position when connecting the unit to the mains. + Please note: Merely switching the unit off does not mean that it is fully disconnected from the mains. To disconnect the unit from the mains, pull out the mains connector. Before installation, please make sure that the mains connector has not been damaged. If you do not use the unit for an extended period of time, please disconnect it at the mains. 2. 1. 1 CLEAN channel {2} The CLEAN CHANNEL LED lights up when the channel is active. {3} The VOLUME control determines the volume of the CLEAN channel. {4} The BASS control in the EQ section allows you to raise or lower the bass frequencies on the CLEAN channel (VT30FX only). {5} The TREBLE control adjusts the treble frequencies on the CLEAN channel (VT30FX only). {6} Press the CHANNEL button to switch between the CLEAN and OVERDRIVE channels. The channel LED lights up when the channel is activated. With all models you can also switch between channels using the footswitch provided. 2. 1. 2 OVERDRIVE channel {7} The OVERDRIVE CHANNEL LED lights up when the channel is active. {8} The GAIN control determines the amount of gain applied and hence the degree of distortion in the OVERDRIVE channel. {9} The BASS control in the EQ section allows you to raise or lower the bass frequencies. [10] Use the MID control for additional, highly characteristic adjustment of the midrange, so as to easily create traditional as well as ultra-modern guitar sounds. [11] The TREBLE control adjusts the treble frequencies. + On the VT30FX, the controls {9}, (10) and (11) are effective on the OVERDRIVE channel only, since this amplifier has a dedicated equalizer for the CLEAN channel (see also {4} and {5}). [12] The VOLUME control adjusts the volume level of the OVERDRIVE channel. 2. 2 Rear panel Fig. [. . . ] = Consult the dealer or an experienced radio/TV technician for help. Important information: Changes or modifications to the equipment not expressly approved by BEHRINGER USA can void the user's authority to use the equipment. FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION VIRTUBE VT15FX Responsible party name: Address: BEHRINGER USA, Inc. 18912 North Creek Parkway, Suite 200 Bothell, WA 98011, USA Phone: +1 425 672 0816, Fax: +1 425 673 7647 Phone/Fax No. : hereby declares that the product(s) VIRTUBE VT15FX complies/comply with the FCC rules as mentioned in the following paragraph: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ]