User manual BEHRINGER VT50FX

[. . . ] VIRTUBE VT100FXH/VT100FX/VT250FX/VT50FX User Manual A50-45733-00003 VIRTUBE VT100FXH/VT100FX/VT250FX/VT50FX Important Safety Instructions 1) Read these instructions. 5) Do not use this apparatus near water. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. [. . . ] {6} With the MIDDLE control you can raise or lower the midrange frequencies on the CLEAN channel. {7} The TREBLE control adjusts the treble frequencies on the CLEAN channel. {8} Press the CHANNEL button to switch between the CLEAN and OVERDRIVE channels. The channel LED lights up when the channel is activated. With all models you can also switch between channels using the footswitch provided. Tab. 2. 1: Effects [19] The FX LEVEL control adjusts the mix ratio between the original and the effect signal. [20] The REVERB LEVEL control determines the effect intensity of the additional reverb effect. [21] The FX LOOP MIX control (VT100FXH and VT100FX only) determines the effect intensity of the external effect (see Chapter 2. 2. 1 FX LOOP). 2. 1. 4 MASTER section [22] The MASTER VOLUME control adjusts both the overall volume and the line out/headphones volume. [23] The CD IN connector allows you to connect the output signal of a CD player, tape deck, or CD/MD walkman. For example, you can play back music CDs or CDs accompanying a guitar tutor while practising. This connector can also be used as a LINE OUT output. In this case, the guitar signal is output with no speaker simulation applied and can be routed to an external amp or mixing console. This will not mute the VIRTUBE's built-in loudspeaker. [24] The LINE OUT/PHONES jack is for headphones connection. Internal speaker simulation is applied to the headphones signal in order to produce an authentic signal. The VIRTUBE's built-in loudspeaker is muted when this connector is used. + The headphones output signal can also be routed to a mixing console or other sound reinforcement system. A suitable power cord is included with the unit. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses must be replaced with a fuse of the same type and rating. On some units, the fuse holder can be switched to one of two positions, i. e. Please note: when operating the unit outside Europe at 120 V, a higher fuse rating is required (see Chapter 4, "Installation"). [. . . ] This also applies to defects caused by normal wear and tear, in particular, of faders, crossfaders, potentiometers, keys/buttons, tubes, guitar strings, illuminants and similar parts. Damage/defects caused by the following conditions are not covered by this warranty: = improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. = connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. = damage/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. [. . . ]