User manual BEHRINGER VX2000

[. . . ] VX2000 Users Manual Version 1. 2 July 2003 ULTRAVOICE ENGLISH DEUTSCH ULTRAVOICE VX2000 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 7) Do not block any ventilation openings. [. . . ] You have found the best setting for this parameter, when the difference to the unprocessed signal can be heard only by way of a direct A/B comparison with the IN/OUT switch. The MASTER FADER adapts the output signal to meet the input sensitivity of downstream devices (e. g. DAT or harddisk recorder). + When you adjust the signal levels, you should start with the lowest level possible and raise it slowly until the levels have been adapted properly. If you start with too high a level, you risk damaging the input stages of downstream devices! ATTENTION! + We would like to bring your attention to the fact that extremely loud sound levels may damage your hearing as well as your headphones. Please lower all MASTER knob leftwards before powering up the unit. The six OUTPUT LEVEL LEDs read the output level from 10 through +15 dB. Use the POWER switch to power up your VX2000. The POWER switch should always be in the Off position when you are about to connect your unit to the mains. Attention: The POWER switch does not fully disconnect the unit from the mains. Unplug the power cord completely when the unit is not used for prolonged periods of time. + 2. CONTROL ELEMENTS 7 ULTRAVOICE VX2000 2. 6 Rear panel Fig. 2. 6: Rear panel connectors of the ULTRAVOICE This is the balanced XLR connector for microphones (MIC) or LINE-level signals. The LINE input is on a balanced 1/4" TRS jack. This is the INSERT section on two 1/4" mono jacks that provides the SEND and RETURN to other effects devices. The signal is taken post-LO CUT-filter (input stage). The XLR RECORDING output is for DAT/hard-disk recorders, etc. These are the MAIN outputs of the ULTRAVOICE, which are on balanced XLR and 1/4" TRS jacks. The mains connection is achieved via the standard IEC connector. The serial number is located on the rear of the unit. Please take a few minutes and send to us a completely filled out warranty card within 14 days of the original date of purchase. Otherwise, warranty claims may be rendered invalid. Or fill out the warranty information online at www. behringer. com. [. . . ] This also applies to defects caused by normal wear and tear, in particular, of faders, potentiometers, keys/buttons and similar parts. Damages/defects caused by the following conditions are not covered by this warranty: s improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. s connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. s damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. [. . . ]