User manual BEHRINGER ZMX8210

[. . . ] ZMX8210 User Manual A50-17433-00002 ULTRAZONE ULTRAZONE ZMX8210 Important safety instructions 1) Read these instructions. 5) Do not use this apparatus near water. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. [. . . ] = HIGH: This boosts/cuts frequencies above 10 kHz by a maximum of ±15 dB. Buses [16] LEDs: When the CLIP LED lights up, attenuate the output level by using the LEVEL knob [17] to avoid clipping. [17] LEVEL: This knob adjusts the output level of the bus outputs OUT L, OUT R and AUX. Mains [18] POWER: The POWER switch powers up the mixer. The POWER switch should be in the Off position when connecting the unit to the mains. 2. 3: Connections of the ZMX8210 [19] FUSEHOLDER/IEC power receptacle: The connection to the mains is established through an IEC connector. It meets all of the international safety certification requirements. When replacing the fuse, you need to use the same type. + Before you change the fuse, switch off the device and pull the plug to avoid electric shock or damage to the device. [20] REMOTE: This connector is used for connecting components to remote control the ZMX8210. = It is possible to connect a simple potentiometer to remote control the volume of the LEFT and RIGHT buses (see Chapter 3. 1. 3). = Connect a push-button switch and two control diodes to remote control the CH SELECT switch {10} of channels 7 and 8 (see Chapter 3. 1. 3). [21] BUS LINKS: Use this connector to link two ZMX8210s together to provide additional inputs (signals). The three output buses LEFT/RIGHT/AUX are linked together using the connector. The mute signal of the ZMX8210 which is set to be the master is also transmitted so that the mute function of the master is also able to mute the buses of the slave. [22] SLAVE/MASTER: The switch places the ZMX8210 in the master or slave mode of operation. When the switch = is pressed, the ZMX8210 is placed in the slave mode of operation. = is not pressed, the ZMX8210 is placed in the master mode of operation. + The ZMX8210 needs to be used in master mode when no additional units are connected!+ When more than one ZMX8210 are connected, only one unit is allowed to be in master mode. The other units need to be placed in the slave mode of operation. [23] AUX/OUT R/OUT L: Balanced signal outputs for buses AUX, RIGHT and LEFT. 6 Controls and connectors ULTRAZONE ZMX8210 In case you need to use further signals, simply link to units together. [. . . ] In no event shall the liability of BEHRINGER exceed the invoiced value of the product. § 5 Warranty regulations 1. Warranty services will be furnished only if the product is accompanied by a copy of the original retail dealer's invoice. Any product deemed eligible for repair or replacement under the terms of this warranty will be repaired or replaced. 1 Customers in the European Union please contact BEHRINGER Germany Support for further details. Technical specifications and appearance are subject to change without notice. [. . . ]