User manual BEKO BKK 2127 P

[. . . ] ⷠWhen the ironing is finished, always pour out the remaining water. The iron must be unplugged during this operation. ⷠWhen filling and pouring water, always unplug the iron. ⷠDo not leave the iron unattended when plugged. [. . . ] at the same time , use the shock steam button frequently. This will both increase steam performance and clear away the dust that may have accumulated in the steam channels. After this operation, always use the softened water that you will obtain from the water-softening unit provided with your iron. Otherwise, steam channels of the iron will calcify in time to finally become unusable. Then fill tap water into the upper part of the water-softening unit that was provided with your iron and place it over the lower part. In a short time, the water in the upper part shall be filtered down to the lower part. Always do the following checks before filling water: Water tank must be completely empty and the iron must be unplugged. You can pour out the water in the iron by opening the water-filling cap and tilting the iron forward. And slightly lean the horizontal iron forward to fill the water tank with the softened water whose lime has been filtered as shown in Figure 2. (Figure 3) Make sure that when the iron is in upright position the water does not go above the maximum line on the transparent water tank. Temperature setting After inserting the plug in an earthed socket, set the temperature setting using the setting button according to the type of clothes and place the iron in upright position. When steam ironing, temperature setting must be at · When temperature setting is done; thermostat light will be on until the base reaches the set temperature and will remain on during the periods in which the heating element operates during ironing. You may start ironing after the thermostat light goes off. Steam Ironing When the thermostat light goes off while the steam setting button is in position, temperature is sufficient to generate steam. You can have continuous steam at this position. Even when ironing without steam, fill the iron with water in order to use the water spray when necessary. When using the iron for the first time, fill the water tank twice with tap water and vaporize it. this is important for cleaning the water channels and for steam performance. Press shock button and shake the iron from time to time during vaporisation. Always use softened water in the following ironing operations. Dry ironing You can do dry ironing when the steam setting button is in position. Make sure you fill water in the tank in order to use the spray button when Allow 5 to 10 seconds after pressing 4-5 times. [. . . ] Water softening unit When the tap water in the iron has been vaporised, its lime content shall accumulate in the steam channels, which will lower steam performance, and to turn yellowish with the effect of heat; and small particles that may flow out with the steam from time to time may stain the cloth. More importantly, your iron may become unusable if steam channels are completely clogged in time. Therefore, always use decalcified You can use the water-softening unit supplied with your iron for that purpose. Place the water-filling unit on the water-filling vessel and fill it with tap water. [. . . ]