User manual BELIMED WD425E

[. . . ] User Operating Manual WD425E Copyright F. Gehrig AG Ballwil, Switzerland 2005 Art. 78563_E Operating Manual WD 425E TABLE OF CONTENT !IMPORTANT NOTICE!. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 !CAUTION! [. . . ] A program can be launched only if the input is complete, otherwise the SW remains in interrogation mode. Input by keyboard: Input N° 66 is passed on as text , , No ID ". Input by barcode reader: Importing N° 0 will be passed on as , , N° ID ". Barcode Type Code 39, the name is limited to 20 characters. Interrogation may activated / deactivated in the configuration module 5. 3. 5 Identification Batch Content Importing N° of wash goods (e. g. Sieve trays) by keyboard or importing wash goods name or N° by barcode reader for batch documentation. With active Batch ID and open door, instead of , , UC door open ", the following is displayed: Read Batch Content N° = -- ?The machine either reads a 2-digit number of the 6 program keys from 11 - 66 or a text or a N° by barcode scanner. 36) or name is passed on to the printer or to the digital documentation system 8565 and assigned to the respective batch. Rev. 1. 1, LS Page 17 of 34 78563_E rev 1. 1. doc Operating Manual WD 425E As a maximum, 18 objects may be imported. The input must always be completed by N° 0. It is not possible to enter the same number or name twice. A program can be launched only once the input is complete, otherwise the SW remains in interrogation mode. Input by keyboard: Entering N° 66, text , , No ID" is passed on and the procedure is terminated. Input by barcode reader: If no object needs to be entered, e. g. OP shoes, inputting N° 0 will terminate the procedure. The reading process may be terminated at any time by the , , IO" key. At he end, always conclude with N° 0. On the display, indication of number of batch contents terminate the procedure. Once the maximum of 18 batch contents is reached, following inputting the 18th item, instead of , , Read batch content ", , , Max batch content " appears and the importing will be terminated without entering N° 0, i. e. the program may be launched. N° Batch Content 12 The rack may be pushed in machine. The length of the name is limited to 12 characters. [. . . ] The pressure sensor PR is defective. 176 During leak test, depending on setup calibration, test pressure may fall below 2. 5 mbar per Right endo leaks 30 or 50 seconds. Leak test has indicated presence of a leak. Error code 176 Cause: Right hand endoscope or endoscope adapter has a small leak and must be repaired. During wash phase, the control pressure for endoscope protection could not be main- Right endo leaks tained, the lower limit value ( 160 m bar) of inside pressure in right hand endoscope was Error code 177 undercut. [. . . ]