User manual BELINEA 102015

[. . . ] [ USER MANUAL LCD-Monitor Belinea 10 20 15 ] BELINEA PREMIUM SERVICE The three-year return to base warranty for your Belinea monitor includes all parts and labour. In addition many countries offer a free of charge swap out warranty programme. This does not affect your Statutory Rights. Please visit http://www. belinea. com or call the numbers below for further warranty or service information. [. . . ] However, you can optionally mount the device on a wall or on a monitor swivel arm (optional accessory). Please follow the corresponding instructions (4-hole assembly with a spacing of 4 4 inches (100 100 mm) according to the international VESA FDMI standard). Belinea 10 20 15 - Operating Instructions - 3 ENGLISH UNPACKING Carefully lift the monitor out of the packaging and make sure that all components are included (see fig. Save the original box and packing material in case you have to ship or transport the monitor. To set up the device, you need to assemble the monitor stand. Insert the screw enclosed, tightening it with a coin or a screwdriver, so that the stand base is attached securely to the stand post. You can adjust the height of the base. MENU MENU MENU MENU SELECT/AUTO SELECT/AUTO SELECT/AUTO SELECT/AUTO Power cord Audio cable VGA cable DVI-D cable (optional) Figure 1. LCD Monitor When the base of the monitor is extended, you can tilt the monitor 90 (Pivot function). CONNECTING To connect the monitor to your PC . . . . . . . . . . . . . . . . . . . . . . . . Make sure that the PC and monitor are unplugged. Connect the 15-pin signal cable to the monitor and the PC (see fig. The monitor is equipped with a DVI-D connector. If you have a graphic card with a digital DVI-D connector (24-pin socket), then connect one end of the DVI-D cable (optional) to the DVI-D connector of your monitor (see fig. 2b), the other end to the computer. DVI-D cable Figure 2b. Connection via the DVI-D interface Signal cable Figure 2a. Connecting the monitor to the PC Figure 3. Connecting the monitor to the power source Connecting the audio cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . If your computer is equipped with an audio output port, then connect one end of the sound cable to the audio input connector of the monitor ( in fig. 3) and the other end to the Line-Out connector of the computer. To connect the monitor to the power source. . . . . . . . Connect the separate power cable ( in fig. 3) to the monitor and a grounded outlet. The monitor is equipped with a main power switch located on the back, next to the power cable socket ( in fig. First start your PC and then turn on your Belinea monitor using the power switch ( in fig. Adjust the image to meet your requirements (see the following sections "Basic Setup" and "Image settings using the OSD menu"). [. . . ] This also applies to those devices for which upon receipt, it is found that they are not covered by the warranty. In these cases, MAXDATA reserves ownership of the exchange device provided and is entitled to demand its return. MAXDATA reserves the right to charge costs incurred for unsuccessful attempts to collect a device that has been registered as defective from the customer. If an exchange device is not provided in spite of a period having been set, MAXDATA is entitled to charge the net sales price as per the current price list plus the processing costs incurred. [. . . ]