User manual BELKIN F5D6020CE1

[. . . ] 13­19 STEP 2: Connect your computers to Router . 20-22 STEP 3a: Setup your computers for networking . 23­32 STEP 3b: Setting up Wireless Computers for Connection to the Router . 33-34 Step 4: Configuring your Belkin Wireless Cable/DSL Router (the Router) for connection to the Internet . [. . . ] This will tell the Router that the ISP provides a dynamic IP address. Click "MAC Cloning/Entry" on the left-hand side of the screen. The following screen will appear. 39 Step 4: Configuring your Belkin Wireless Cable/DSL Router (the Router) for connection to the Internet 4. If your ISP assigned you a host name, enter the host name here. If your ISP binds the connection to a MAC address, you will need the Router to copy that MAC address. If your ISP does bind your MAC address, or you are not sure, follow this step. This will clone (copy) the MAC address of the first PC connected to the Router. This will also ensure that the ISP, if it binds your connection to that MAC address, that it will remain active. Click "Enter" to save the settings. Finishing Dynamic Setup At this point, initial setup of the Router is now complete for a dynamic configuration. To verify that your Router is connected to the modem, click on "Status" in the lower left hand corner of the router setup page. Other computers you have connected to the router should also have access to the Web. If you are having problems, see the troubleshooting section of this manual. PPPoE If you have a DSL modem and your Internet Service Provider gave you software such as WinPOET or Enternet300 that you use to connect to the Internet, follow these steps to set up your Router for PPPoE. It is recommended that you uninstall the software that your ISP provided to you for connecting to the Internet. Before uninstalling the software from your computer, be sure you have a copy of the software in the event you want to re-install it at some point. If you do not uninstall the PPPoE software provided to you by your ISP, your connection may not work properly. To uninstall the software, Click on "Start" then "Settings" then "Control Panel". 43 Step 4: Configuring your Belkin Wireless Cable/DSL Router (the Router) for connection to the Internet 2. Double-click on "Add/Remove Programs" 3. A list of programs installed on your computer will be displayed in the window. Locate the PPPoE software that was provided to you by your ISP and highlight it by clicking on it one time. Click the "Add/Remove" button and follow the steps to complete the removal of the software. [. . . ] Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Exposure to Radio Frequency Radiation. The radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such manner that the potential for human contact normal operation is minimized. When connecting an external antenna to the device, the antenna shall be placed in such a manner to minimize the potential for human contact during normal operation. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation. Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]