User manual BELKIN F6C.B550.750AVR

[. . . ] INTRODUCTION Thank you for purchasing a Belkin Uninterruptible Power Supply (UPS). Each year, several natural and man made occurrences put the power supplied to your electronics in your home or office in jeopardy. At risk are your hardware, software and data because of these power problems. IMPORTANT SAFETY INSTRUCTIONS The UPS charges its battery whenever it is connected to the utility power. Plug in Power Devices Plug your devices into the AC outlets on the top of the UPS. [. . . ] 3 SITE WIRING FAULT (ON REAR PANEL) Solid Red Note!Before installation, please inspect the UPS Upon receipt. Connect to AC Utility Power Connect the AC inlet to utility power via the power cord. Check whether the Site Wiring Fault indicator is lit or not. Charging the Battery For best results, charge the battery for 8 hours prior to initial use. To fully utilize the Bulldog Plus Shutdown Software; you will need to connect the UPS to your computer. The communication port will provide the following features: 1. Monitoring battery status and condition 4. Use the ON/OFF/TEST UPS power switch function to schedule UPS for power saving Using the USB cable (provided), connect the cable to your UPS then connect the other end to the USB port on your computer. Caution: Use only the factory-supplied UPS monitoring cable. Software Installation (Installation Optional) To fully utilize the UPS and its software, your computer must be able to operate the following operating systems: Windows98/ ME/ NT4/ 2000 / 2003/ XP and have a USB port. B) Your UPS features the Bulldog Plus Shutdown Software. This allows you to protect and save your data should a power outage occur, as well as safely shutdown your computer in your absence. Please be sure to close out of all applications prior to installing the software. To install the software, please place the CD into the CD drive of your computer. If this does not occur, go to the Run feature on your Start icon (lower left corner) on your screen. Please enter the CD drive, it may be D: Upon entering the drive run setup. exe. Should you continue to have a problem, please refer to your computer's owner's manual for the correct drive. The "Welcome to the Belkin Bulldog Plus Product Installation Browser" will appear. Please click Install and select the Windows version. The Bulldog Plus Installation window will appear. Please choose the appropriate software to install. Install Shield Wizard will appear onscreen, click Next. Please read the License Agreement and click Yes. [. . . ] The entire risk of the use, results and performance of the software, program and documentation is borne by you. Should any or all of the product, software, program, documentation, or related information, goods or services be defective, misused, unsuitable or cause or give rise to any harm or liability whatsoever, you, not Belkin or its associates, dealers or agents, assume the entire liability, cost of repair, correction or any payment or other remedy whatsoever. Furthermore, no warranty or guarantee is made regarding the use or results of the product, software, program, documentation, or any related information, goods or services in terms of correctness, accuracy, reliability, timeliness or otherwise. You use and rely on the program at your own risk. [. . . ]