User manual BELKIN F6H375.550USB

[. . . ] INTRODUCTION Thank you for purchasing a Belkin Uninterruptible Power Supply (UPS). Each year, several natural and man made occurrences put the power supplied to your electronics in your home or office in jeopardy. At risk are your hardware, software and data because of these power problems. IMPORTANT SAFETY INSTRUCTIONS Please save this manual! [. . . ] To install the software, please place the CD into the CD drive of your computer. If this does not occur, go to the Run feature on your Start icon (lower left corner) on your screen. Please enter the CD drive, it may be D: Upon entering the drive run setup. exe. Should you continue to have a problem, please refer to your computer's owner's manual for the correct drive. Phone/Fax/Modem Protection IN OUT OUT #5 Diagram 2 AC Input Power Cord (See #1 on Diagram 2) Provides power to your UPS. Audio/ Video surge protection port (see #2 on Diagram 2) (Only F6B550-USB model) The Audio/ Video cable is surge protected. There is one input port and one output port. Phone/ Fax/ Modem Surge Protection (See #3 on Diagram 2) The Phone/ Fax/Modem lines are surge protected. There is one input jack and two output jacks. This allows you to split one telephone connection to two separate devices. AC Breaker (Circuit Breaker; See #4 on Diagram 2) Should a power overload occur, the circuit breaker would trigger the UPS to turn off AC power. In order to restore the power, depress the circuit breaker button to reset, then depress the Power button. USB communication port (see #5 on Diagram 2) Your UPS features a USB communication port. Installation of the cable and software is optional. This allows the UPS to connect to your computer. The Bulldog Software will not work if the UPS is not connected to you computer. This does not mean the battery backup feature will not work without the software and cable installed. The UPS will still provide backup power but you will be unable to utilize the data management capabilities of the software. Solid Red SITE WIRING FAULT 3. 4. Chart 1 5. b) BATTERY REPLACEMENT PROCEDURE 1. 4 Replacement requires removing the battery cover plate on the back or bottom of the UPS. Remove the battery cover plate on the back of the UPS (Fig. 1). Disconnect the insulated connectors from the battery terminals (Fig. 2) then put the battery wire into indentations. Remove the battery then insert a new battery pack, and push the connectors onto the battery terminals (Fig. 3) 4. NOTE: There may be a small spark at the battery terminals when reconnecting the connectors. This is normal and will not harm you or the UPS. Close the battery cover (Fig. [. . . ] This User License Agreement (Agreement") contains the terms and conditions under which limited use of the product is licensed to you. PLEASE READ THIS NOTICE CAREFULLY DO NOT USE THE SOFTWARE OR PRODUCT UNTIL YOU HAVE READ AND AGREED TO THIS AGREEMENT. IF YOU USE THE SOFTWARE AND PRODUCT, YOU ARE AGREEING TO THE TERMS AND CONDITIONS SET OUT IN THIS AGREEMENT. IF YOU DO NOT ACCEPT THESE TERMS AND CONDITIONS, YOU MUST RETURN THE UNOPENED PRODUCT WITH THE DISKS INSIDE TO THE PARTY FROM WHOM YOU RECEIVED IT. [. . . ]